Ignition Switch Problems of Chrysler Concorde
Chrysler Concorde owners have reported 6 problems related to ignition switch (under the electrical system category).
#1 - Ignition Switch problem of the 1998 Chrysler Concorde
The VIN of this vehicle is 2C3HD46JXW_. The vehicle is a 1998 Chrysler Concorde. The contact stated the brake and power steering lines were covered with excessive rust. The contact stated the power steering malfunctioned due to fluid leaking. The contact took the vehicle to a local mechanic in order to have the brake and power steering lines replaced. The contact also stated the ignition switch was faulty which made it possible to remove the key when the vehicle was turned on. The contact did not notify the manufacturer of the failure. The contact stated the vehicle was unsafe to drive. The failure mileage was 152,000. It was Friday, July 22, 2011 when this ignition switch issue happened.
See all problems of the 1998 Chrysler Concorde.
#2 - Ignition Switch problem of the 2002 Chrysler Concorde
The vehicle involved is a 2002 Chrysler Concorde. The VIN of the problem Concorde is 2C3HD36M62_. Gears engage without the key in the ingnition. Automaitc transmission shifter could be moved from the park position without the key in the ignition switch. Ea03011. The failure date was October 8, 2003.
See all problems of the 2002 Chrysler Concorde.
#3 - Ignition Switch problem of the 2000 Chrysler Concorde
The VIN of this Concorde is 2C3HD46R8Y_. Chrysler Concorde 2000 engine seized at 69000 miles too much money to repair timing belt/chain replaced at 55000 miles door locks replaced ignition switch replaced engine quit with family in car during 65 mph. This issue happened on Tue., Dec. 5, 2006.
See all problems of the 2000 Chrysler Concorde.
#4 - Ignition Switch problem of the 1999 Chrysler Concorde
The vehicle is a 1999 Chrysler Concorde. The VIN of this vehicle was 2C3HD46R1X_. In April 2005 owner put key in the ignition switch and it got stuck. The key would get stuck more and more often, then wouldn't turn at all. The key would get stuck in the ignition, allowing the car to be left with the key in it. Once the key was stuck in the ignition for weeks, and had to be repaired by a locksmith. The locksmitih advised consumer that this was a common problem with these type of cars. It was a 1999 Chrysler Concorde. The problem returned becuase the key sometimes getting stuck. Owner could not turn the key over. If consumer fiddled with the key it will turn over. Dealership advised consumer that the pin inside the ignition interlock broke off and then it wont work anymore. The ignition switch was eventually recalled 04v021000, but dealership advised that it was not related to this problem with the ignition. This ignition switch problem happened on 05/01/2005.
See all problems of the 1999 Chrysler Concorde.
#5 - Ignition Switch problem of the 1998 Chrysler Concorde
The vehicle having this issue was a 1998 Chrysler Concorde. Connecting pin on shifting bracket is broken which allows key to be removed from ignition switch without vehicle being in park . Please give any further details.
#6 - Ignition Switch problem of the 1996 Chrysler Concorde
The vehicle having this issue was a 1996 Chrysler Concorde. While traveling at 55 mph all of a sudden the vehicle stalled. Took vehicle to dealer for check up, and results showed that the ignition switch needed to be replaced again for the second time. The consumer stated that the speedometer started having problems. The heater started having problems. This issue happened on Tue., Dec. 28, 2004.
See all problems of the 1996 Chrysler Concorde.
Other Electrical System related problems of Chrysler Concorde:
|Problem Category||Number of Problems|
|Electrical System problems||20|
|Horn Assembly problems||6|
|Ignition Switch problems||6|
|Car Will Not Start problems||3|
|Dash Wiring problems||2|
|Fuses And Circuit Breaker problems||2|
|Battery Cable problems||2|
|Ignition Module problems||2|
|Underhood Wiring problems||1|
|Dashboard Failed problems||1|
|Instrument Panel Failure problems||1|