Steering Related Problems of the 1996 Chrysler Sebring

Table 1 shows six common steering related problems of the 1996 Chrysler Sebring. The number one most common problem is related to the steering tie rod assembly (four problems). The second most common problem is related to the steering (three problems).

  Recently reported Steering problems of the 1996 Chrysler Sebring

The Steering Tie Rod Assembly problem

: the consumer stated both tie rod ends fractured on two separate occasions. The first time, while backing out of the driveway, the front tires went in opposite directions and the vehicle would not move forward or backward. The tie rod end was replaced.   Read details...

The Steering problem

Recall #750 front lower control arm ball joint alleged repaired 02-10-98. This is a new (10-08-09) recall. Due to my vehicle was at the dealer, it was asked if the numbers of the ball joints and control arms numbers could be checked to see if original Chrysler or aftermarket quality parts were used.   Read details...

The Steering Knuckle Spindle problem

Right front spindle broke, causing right front wheel to bent/flat tire/vehicle rolled over/injury.   Read details...


  Steering related problems in other Chrysler Sebring model year vehicles:



Switch Make:
Switch Model:
Fuel Economy of Sebring Vehicles
Sebring Service Bulletins
Sebring Safety Recalls
Sebring Defect Investigations