Dodge Journey owners have reported 10 problems related to brake master cylinder (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Dodge Journey based on all problems reported for the Journey.
I bought this vehicle brand new since I put at least 3-4 sets of brakes on this car and 2 sets of rotors a year since owning it. I have 56000 miles on my car I know that brakes and rotors are not covered under warranty it's regular maintenance on a vehicle. But this is over kill. My car is currently in the shop I believe that my anti lock brake pump assembly is out. I've replace the master cylinder and 2 brake lines I still have no pedal to speak of. The first month I owned this car the brakes and rotors were replaced by barreth in washington, mo.
See all problems of the 2010 Dodge Journey .
Takara recall: when leaving work I started my car and began to back out of the parking lot when I went to push on my brakes to stop my car my brake pedal went all the way to the floor as if I had nothing but air. I called and had the car towed to a local shop 4 different master cylinders put on the car two new calipers on the driver side front and back replaced along with a new abs module and brake line hose on the front left side 2500. 00 later and I still have no front left brakes!!!! complete nightmare and it is completely unsafe not one person can figure out what the problem is OH I shall add we also replaced the brake pads!.
See all problems of the 2009 Dodge Journey .
I have a 2010 Dodge Journey that we have replaced the brake pads at least 3 times since December we have replaced the master cylinder and calipers. The brake continue to heat up and cause issues. We have also replaced both the driver and passenger side brake hoses.
I have had the rotors, pads, calipers, and master cylinder replaced several times in the past 7 years, more than any other vehicle I have owned in my 45 year lifetime. I have had all of my car's repairs done through sears so the brakes are warrantied. I had the master cylinder replaced in Dec. 2016 and now having to turn around and having to replace them again.
Tl- the contact owns a 2013 Dodge Journey. The contact stated that while driving at approximately 20 mph, the brake pedal was depressed failing to stop the vehicle as it travel to the floorboard. The contact stated that in order to stop the vehicle, the brake pedal had to be pumped several time. The contact coasted over to the side of the road waited a few minutes and was able to drive the vehicle to his residence. There was no warning indicator illuminated. The vehicle was taken to an independent mechanic where it was diagnosed that the master cylinder needed to be replaced. The vehicle was not taken to a dealer. The vehicle was not repaired. The manufacturer was contacted and made aware of the failure and did not offer further assistance. The approximate failure mileage was 113,000. The VIN was not available. Aw.
See all problems of the 2013 Dodge Journey .
The contact owns a 2013 Dodge Journey. While driving approximately 35 mph, the brakes malfunctioned and the vehicle crashed into a trailer. The driver sustained injuries to the legs and back, which required medical attention. The vehicle was towed and a police report was filed. An independent mechanic diagnosed that the brake master cylinder rod failed and caused the brakes to malfunction. The manufacturer was not notified of the failure. The failure mileage was 80,000.
2009 Dodge Journey. Consumer writes in regards to vehicle faulty brake system issues. The consumer stated all four wheels were locked which left the vehicle immobile. The brake pads, rotors, calipers and master cylinder were all replaced and the vehicle still can't be driven.
Tl-the contact owns a 2009 Dodge Journey. The contact stated that while driving 30 mph, the brakes went out and the contact had to press the brakes extremely hard to stop the vehicle. The vehicle was taken to a dealer where it was diagnosed that the power transfer unit assembly fractured causing the master cylinder to stop working. The vehicle was repaired. The manufacturer was made aware of the issue. The failure mileage was 55,266. Ad.
While driving I was approaching a stop sign and depressed the brake pedal to stop. I kept pressing to stop but the pedal went all the way to the floor and I could not stop. I had to roll through the stop and make a hard right turn. If there was traffic I probably would have had an accident. This is the second time this vehicle had breaking issues after the first event which was aprx 15000 iles ago the dealer said the problem was the master cylinder which they replaced. Action should be taken against Chrysler before someone gets hurt or killed.
Around 14,000 miles the brake pedal would sink. Dealer found bad master cylinder. During further inspection of brake system they also found front brake pads worn. At 24,000 the rear pads and rotors are no good. You can feel car shimmy when slowing down on freeway. Pre-mature failer on pads and rotors. Car is mostly freeway miles with no hard braking.
|Problem Category||Number of Problems|
|Service Brakes problems||
|Brake Disc Pads problems||
|Brake Disc Caliper problems||
|Brakes Failed problems||
|Brake Abs Warning Light problems||
|Brake Grinding Noise problems||
|Brake Sensor problems||
|Brake Light On problems||
|Brake Master Cylinder problems||
|Brake Squeaking Noise problems||