Ford Crown Victoria owners have reported 5 problems related to differential unit (under the power train category).
The contact owns a 2005 Ford Crown Victoria. When the vehicle was checked for differential fluid, the housing was pressurized and air was blowing out of the filler tube. The vehicle was inspected by a Ford dealer and they stated that there was no failure. The contact, who is also a mechanic, checked the vehicle and also noticed the failure several times on vehicles of the same year, make, and model. The failure mileage was 23,000 and the current mileage was unknown.
See all problems of the 2005 Ford Crown Victoria.
The contact owns a 2003 Ford Crown Victoria. The differential on the vehicle is worn out. The rear bearings were worn and caused the axle to separate from the housing. While driving 45 mph, the bearings began smoking and smelled like hot asphalt. Smoke also rose from the rear of the vehicle. The gear oil leaked out of the bearings and onto the brakes. The dealer inspected the vehicle and stated that permission was needed from the manufacturer because the vehicle was out of warranty. Afterwards, the dealer repaired the failure under recall number 04v328000 (suspension:rear). The differential failed six months later and the dealer currently refuses to work on the vehicle unless the contact pays for the repairs. The current mileage was 94,000 and failure mileage was 80,344.
See all problems of the 2003 Ford Crown Victoria.
I have had the car in my hands for 5 days and then it has been in the shop the last week. There is a problem with the rear end it was there when I got the car and got wrose in the 850 miles that I have been able to put on the car. Ford now has the rear differential all a part and can't find the problem. I have said that it must be a bad baring and just put a new one on and Ford will not. They would like to just rip apart my new car.
Vehicle is having same symptoms as mentioned in recall # 98v322000. Differential is also making noise, possibly losing fluid.
See all problems of the 1998 Ford Crown Victoria.
Consumer complains of a defect and vibration in the drive shaft assembly. The drive shaft assembly has been replaced twice and the differential assembly with no favorable results.
See all problems of the 2002 Ford Crown Victoria.
|Problem Category||Number of Problems|
|Power Train problems||
|Automatic Transmission problems||
|Axle Shaft problems||
|Axle Assembly problems||
|Power Train Driveline problems||
|Differential Unit problems||
|Automatic Transmission Park/neutral Start Switch problems||
|Axle Shaft Seal problems||
|Automatic Transmission Control Module problems||
|Automatic Transmission Torque Converter problems||