GMC Sierra owners have reported 15 problems related to front suspension wheel bearing (under the suspension category). The most recently reported issues are listed below.
2006 GMC Sierra. Consumer writes in regards to recall concerning hub bearing
the consumer also stated, the brakes were not functioning properly. There were times, when it felt as though the brakes didn't grab.
See all problems of the 2006 GMC Sierra .
The contact owns a 2005 GMC Sierra. While driving 45 mph the left front driver side tire had begun to wobble. Moments later, the tire had suddenly locked, which caused the vehicle to come to a complete stop. A mechanic stated that the wheel bearing needed to be replaced. The current and failure mileages were 60000.
See all problems of the 2005 GMC Sierra .
Front driver side and passenger side wheel bearings and abs sensors went bad. I have spoke to other owners of similar vehicles and they also had trouble.
Abs brake activates at slow speeds. Wheel hub bearing problem.
See all problems of the 2004 GMC Sierra .
The contact had recall 05v37900 repair work done on the anti lock brakes. Approximately one month later, while applying the brakes, he heard a loud grinding noise. The consumer was only going 8-10 mph and the consumer traveled 200-300 feet before he was able to come to a stop. He took the vehicle to the dealership, and they stated the wheel bearings needed to be replaced. Updated 01/11/06.
See all problems of the 2000 GMC Sierra .
There have been no injuries due to the front hub bearing being worn but when we make a turn we always felt a knocking in the steering wheel which made us think of something being loose. We had a mechanic look at it just by shaking the wheel you could tell something was worn. We are trying to find out if there is or going to be a recall on it because the truck is a 2003 Sierra and all mechanics we've spoke to do not believe the bearing she be worn already. This has left us without a vehicle until it gets resolved. Thank you for your time.
See all problems of the 2003 GMC Sierra .
Both right and left front wheel bearings found to be worn out. Movement of the tire at top from 1 to 2 inches. No steering or braking problems were detected before the condition was found as part of the missouri state safety inspection. This problem can only be corrected by replacing the hub assembly. Estimate of repair cost $1000. 00.
See all problems of the 2001 GMC Sierra .
Consumer states: anti-lock brake system, when applying it makes weird noise, and has to push brakes to the floor. Had to do 4 times, was under 5 mph and pedal kicked back, and it grabbed. Just got abs serviced and new fuse put in. Had to take out fuse for the brakes to work properly. Could hear whinnying noise before taking out the fuse, and light came on at the same time. Dealer hooked up vehicle to diagnostic machine, replaced right front hub and bearing assembly, and still having the same problem.
See all problems of the 1999 GMC Sierra .
Contact states: at low speeds the abs locked up. The same problem happened to consumer's other GMC Sierra . Dealer said that the front wheel bearing/hub assembly was the problem. When the abs kicked in it resulted in extended stopping distance. No prior warning to the failure.
2002 GMC Sierra experienced extended stopping distance. The vehicle's front end bounced and made noise. It was later determined that the problem was a faulty driver's side front hub bearing assembly. After many phone calls and letter the consumer received a check from the manufacturer. The check covered the part not the labor. The consumer wants to know why this part was recalled in canada but not in the us.
See all problems of the 2002 GMC Sierra .
Contact states: at very low speed anti lock brakes would kick in when consumer would brake instead of braking the vehicle would keep moving, it doesn't matter what the weather condition is. It has been repaired at contact's expense. Contact called gm, they said it needed two new hubs, including the bearings (left and right). Gm covered 1/2 of the cost. Dealer diagnosed it without even looking at the vehicle because they had seen this before.
2002 GMC Sierra denali wheel bearing failure left & right side as well as front differential trouble.
Consumer states while backing out of driveway brake pedal became hard. Consumer could not slow down and resulted in an accident. Mrthe left front wheel bearing was found to be defective. This contained the brake motion sensor which was all one unit, causing the brake failure.
Right front wheel lock up while driving, vehicle tow to a repairs shop and informed of a front wheel bearing failure. Dealer and the manufacturer were notified. Feel free to provide any further information.
2006 GMC Sierra with a front wheel bearing burn out. Consumer states that the wheel bearing burn out was prior to the tire wearing out. Gm decided to seal the bearing to prolong the life. The consumer stated the failure occurred while driving 70 mph. Once he was able to stop the vehicle, the consumer discovered the brake line had broken and a fire had ignited under the vehicle. The axle and all the brake components had to be replaced.
|Problem Category||Number of Problems|
|Front Suspension problems||
|Front Suspension Wheel Bearing problems||
|Front Suspension Hub problems||
|Rear Suspension problems||
|Front Suspension Shock Absorber problems||
|Front Suspension Control Arm problems||
|Rear Suspension Shock Absorber problems||
|Suspension Torsion Bar problems||
|Clunking Noise problems||