GMC Yukon owners have reported 3 problems related to brake grinding noise (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of GMC Yukon based on all problems reported for the Yukon.
: the contact stated the abs system engages at low speeds of approximately 5-10 mph. There is a grinding noise heard as the braking occurs. The brake pedal has to be depressed to the floor before stopping will occur. There is an NHTSA recall, # 05v379000, regarding the hydraulic: antilock. The VIN was not included in the recall.
See all problems of the 2001 GMC Yukon .
The contact stated about three -four weeks ago the abs kicked in at low speeds, and he has no stopping power. The dealer told the contact the bearing hubs needed to be replaced. About two weeks ago he noticed a grinding noise coming from the transmission area. The dealer told him the transfer case needed to be removed and likely replaced.
See all problems of the 1998 GMC Yukon .
The contact stated the abs engage dat low speeds, and was making a grinding noise. This vehicle was not included in NHTSA recall 05v379000. The manufacturer has been contacted, and there was no free remedy offered.
See all problems of the 1999 GMC Yukon .
|Problem Category||Number of Problems|
|Brake Hoses, Lines/piping, And Fittings problems||
|Brake Electric Antilock problems||
|Service Brakes problems||
|Brake Fluid Leak problems||
|Brakes Failed problems||
|Brake Antilock Wheel Speed Sensor problems||
|Brake Light On problems||
|Brake Sensor problems||
|Brake Master Cylinder problems||
|Brake Antilock Control Unit/module problems||