Honda Passport owners have reported 6 problems related to brake pedal and linkage (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda Passport based on all problems reported for the Passport.
The contact owns a 1999 Honda Passport. The vehicle was previously repaired by an authorized dealer for the recall associated with NHTSA campaign id number: 02i002001 (service brakes, hydraulic:antilock). The contact was driving in reverse at a low speed when she applied light pressure to the brake pedal and the pedal depressed abnormally into the floorboard. As a result, the contact simultaneously depressed the accelerator pedal and the vehicle was involved in a crash. A police report was filed but no injuries were reported. The vehicle was not taken to have the failure diagnosed nor was it repaired. The failure recurred within four days again, resulting in a crash. A police report was also filed for the second crash but no injuries were reported. The vehicle was not taken to have the failure diagnosed now was it repaired. The failure and current mileage was 150,000. Updated 01/28/11
See all problems of the 1999 Honda Passport .
I own a 1998 Honda Passport. I was leaving my apartment complex and as I was approaching a stop sign which leads to a highway, my vehicle would not come to a complete stop whle braking. Though I was not speeding my brake pedal was resisting and felt hard as I pressed the brake more firmly. I ended up partially in the highway and an oncoming car slammed into me on the driver side totalling my SUV. The street was wet from rain. As I exited my vehicle I noticed that my brake lights still remained illuminated even though I was not in the vehicle. Mr.
See all problems of the 1998 Honda Passport .
Nar 9-10-03. Consumer complaint on a defective 1998 Honda Passport pursuant to maryland's lemon law. Battery cables replaced, brake warning light illuminates, rear suspension defective, and brakes pedal inoperable.
Brake pedal material made of thin plastic causing it to break.
When applying abs brakes pedal goes to the floor, resulting in extended stopping distance. Also, brake pedal and the gas pedal are located very closely together which causes them to depress at the same time.
The brake and gas pedals are too close, the gas pedal is sometimes pressed when trying to break.
|Problem Category||Number of Problems|
|Brake Electric Antilock problems||
|Brake Abs Warning Light problems||
|Service Brakes problems||
|Brakes Failed problems||
|Brake Master Cylinder problems||
|Brake Antilock Control Unit/module problems||
|Brake Pedal And Linkage problems||
|Brake Disc Pads problems||
|Brake Disc Rotor problems||
|Brake Foundation Components problems||