Camshaft Position Sensor problems of the 2003 Jeep Liberty

Two problems related to camshaft position sensor have been reported for the 2003 Jeep Liberty. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2003 Jeep Liberty based on all problems reported for the 2003 Liberty.

car   Camshaft Position Sensor problem 1
Failure Date: 11/22/2010

After buying the car as Jeep Liberty renegade 2003 used at about 40,000 miles. The second time I drove the car on the interstate the car started stalling and running very rough. I limped in for about 15 miles to the repair shop and problem was diagnosed as a faulty crank sensor. That was replaced and car ran fine for 4 years. Now with 66000 miles the car stall while driving at low speed. Restarted and took car in and problem was diagnosed as a faulty crank sensor again, but part had to be ordered and car was running fine. So I decided to drive car while waiting for the part and next day the car would not start. When tow truck arrived car stated fine but had car towed to repair shop. The sensor was replaced but the shop still was having periodic stalling problem. It was finally diagnosed as a faulty cam shaft sensor which was replaced and now the car is running fine. Looks like Jeep has a problem with the sensors in the Jeep renegade model.

car   Camshaft Position Sensor problem 2
Failure Date: 06/11/2009

Was driving down the road and suddenly lost power. Had to be towed to garage and was told that the crank shaft sensor and cam shaft position sensors were both gone and had to be replaced. Jeep Liberty sport 2003 only has 61000 miles on it.

Switch Make:
Switch Model:
Jeep Liberty Service Bulletins icon-go-page
Jeep Liberty Safety Recalls icon-go-page
Jeep Liberty Defect Investigations icon-go-page
Jeep Liberty fuel economy icon-go-page