Jeep Wrangler owners have reported 8 problems related to turn signal switch (under the exterior lighting category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Wrangler based on all problems reported for the Wrangler.
The contact owns a 2012 Jeep Wrangler. The contact stated that the left and right turn signal switch and the windshield wipers failed to operate. The failure recurred several times. The vehicle was taken to the dealer, but the failure was unable to be determined. The manufacturer was notified of the failure. The failure mileage was 38,000.
See all problems of the 2012 Jeep Wrangler .
2008 Wrangler 2 door 4x4. Around 28,000 miles the turn signal quit working with no warning. Dealer replaced the turn signal switch. Noticed that same day that the turn signal would not stop after making a left turn. Dealer had to replace it a 2nd time.
See all problems of the 2008 Jeep Wrangler .
Wiring overheating and melting blower motor fan switch at 36,500 miles. Wiring overheating and melting multifunction switch for turn signals, headlamps, hazards, etc. . . At 37,800 miles. Unknown cause for either failure. Replaced blower motor control switch assembly after failure myself as it was only $25 usd and 10 minutes time. Now the multifunction switch is doing the same - melting and causing headlamps to fail. Is there a voltage control problem with the electrical systems to cause these failures? will the replaced parts fail again? will a fire result the next time? updated 02-01-08
See all problems of the 2005 Jeep Wrangler .
: the contact stated the following components failed intermittently, the airbag light illuminated, the speedometer and the tachometer showed no reading. The vehicle does not have to be in motion for the problem to occur. The contact believes the problem may be related to the clock spring, although the vehicle has not been inspected by a local dealer. The turn siganl would not cnacel, the dealer repalced the turn signal switch. Uypdated 03/28/06.
See all problems of the 1998 Jeep Wrangler .
Internal contacts failure in turn signal switch renders turn signals, headlights, and hazard warning inoperative. Problems with this switch have also causes other electrical issues. In some cases, this also drains the battery when the vehicle is off. This is a common issue on Jeep Wranglers and requires replacement of the switch.
See all problems of the 1999 Jeep Wrangler .
Turn signal switch failed causing the headlights to flicker when turn signal activated. * et.
See all problems of the 1997 Jeep Wrangler .
When using the left signal light all of the rear lights will come on, and all the rear lights are flashing and won't go off.
Head light dash switch failed.
|Problem Category||Number of Problems|
|Exterior Lighting problems||
|Turn Signal problems||
|Fog Light Switch problems||
|Turn Signal Switch problems||
|Tail Light Switch problems||
|Headlight Switch problems||
|Brake Light problems||
|Turn Signal Flasher Unit problems||
|Hazard Flashing Warning Light Switch problems||