Nissan Murano owners have reported 13 problems related to service engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Nissan Murano based on all problems reported for the Murano.
At 20k miles in our 2015 Nissan Murano, we experienced the car chugging at speeds under 15mph, turning a corner, accelerating from a stop. The chugging was followed by engine revving. This was followed 2 days later by complete failure while driving at highway speeds. The car would not accelerate at all. It had to be towed to the dealership. The service engine light came on after the engine failed. Nissan cannot determine a cause and is replacing the transmission.
See all problems of the 2015 Nissan Murano .
On 4/8/15, while about to make a left turn at a traffic light, my car stalled without any warning. Started up after two attempts. Service engine light came on and has remains on currently. Contacted Nissan specialist on a website who advised it could be crank position and/or camshaft sensor(s). I took it to firestone to have it scanned. Positive for codes p0725(engine speed signal circuit malfunction) and p0340(camshaft position sensor circuit failure). Purchased my vehicle in August 2003. Never notified by Nissan of recall for sensors(NHTSA #03v4550000). Called local dealership on 4/9/16 who advised me that my VIN number is not on the list for my vehicle to be repaired, despite having the same complication identified by Nissan and NHTSA which necessitated the recall. In addition, letter written by thetechnical compliance department of Nissan to the NHTSA, dated 12/4/03, clearly states that my car is included in the list of recalled vehicles. No updated letter or other public information found stating that certain VIN numbers are required to have car repaired. This is a gross safety issue and I am not clear as to why they are refusing to service my vehicle as per the recall. Please address. Thank you.
See all problems of the 2003 Nissan Murano .
Tl-the contact owns a 2007 Nissan Murano. The contact stated that while driving at 40 mph, the vehicle stalled. The contact was able to restart the vehicle after some time. The cvt and service engine warning lights illuminated. The failure recurred on numerous occasions. The vehicle was taken to an independent mechanic who was unable to diagnose or repair the vehicle. The manufacturer was not notified of the failure. The failure mileage was 119,000. Oo.
See all problems of the 2007 Nissan Murano .
On 6/15/15, while on highway my car stalled without any warning. Started up after few attempts. Service engine light came on and remained on. I scanned for error code and I've got p0340 (crank position and/or camshaft sensor(s)). On 6/26/15 I took the car to hilton head Nissan dealer in hardeeville, SC - they scanned it positive for code p0340(camshaft position sensor circuit failure) and they replaced the two sensors. They never told me about Nissan recall for sensors (NHTSA #03v4550000). I found today about this recall and called Nissan dealer on 6/27/16 - they told me the car is to old to apply the recall, despite the fact that Nissan Murano 2003 is specified on the recall and despite having the same complication identified by Nissan and NHTSA which necessitated the recall. In addition, letter written by the technical compliance department of Nissan to the NHTSA, dated 12/4/03, clearly states that my car is included in the list of recalled vehicles. No updated letter or other public information found stating that certain VIN numbers are required to have car repaired. This is a gross safety issue and I am not clear as to why they refused to service my vehicle as per the recall and I had to pay for sensors replacement. Please address. Thank you.
The service engine soon light came on and the engine started to stumble as if it was fuel starved and was losing power and wanted to stall. Putting the car in neutral and goosing the gas at idle at traffic lights kept the vehicle going until I could get it to the dealership. The dealer replaced the cam and crank position sensors. One year later the same two parts failed and were replaced. They lasted less than one day and now the vehicle is at the dealership for major repairs because of either the parts or a combination of the parts and internal engine parts.
See all problems of the 2009 Nissan Murano .
I just purchased this vehicle on 7/15/14, drove it home and it would not start 7/16/14. I was able to get the vehicle started, but the service engine soon light came on and it shut off 2 more times while parked. I was finally able to get it started and running to go about my errands. I stopped to pick someone up from the hospital and it started up, but immediately shut off again. Eventually, it started bucking and shuddering while I was driving and seemed as if it was going to shut off. I was able to get it to the dealer I purchased it from and he is taking responsibility of getting it serviced. The diagnosis was the rear cam position sensor went bad. I called haldemann Nissan in hamilton, NJ to inquire about recalls, as I knew this was a recall issue and was told that my VIN number had no recalls.
Shortly after purchasing our 2009 Nissan Murano in sept 2012 a loud noise was heard at times in the floor board. . . It was discovered to be a broken motor mount. . . This was replaced under 30 day warranty from place of purchase. The sunroof cover also was defective as it would not open completely at times and also required replacing. Since this time in 2013 the wipers do not work properly at all times. . . This has not been recreated for a tech to inspect. . . . Sometimes they do not go as fast as should if heavy rain and other times go too fast if barely drizzling, this is on the intermittent function. February 2014 was due to take in for routine oil change that day and service engine soon light came on that morning. . . Was advised needs new catalytic converter, was at 85k, manf. Warranty went out at 80k, extended warranty we purchased and paid extra for was to cover up to 150k; however, does not cover this part. Nissan says nothing on them, funny they are the ones who made the vehicle, and regardless of this being a used vehicle (we are the second owner) this is not something you can tell in advance is going out. . . We have not had any noise prior and this was first time light came on. This is very costly and something that has to be fixed in order to pass inspection or I will not have a vehicle to drive.
While driving my wife to work my car stopped working and I pulled over to the side of the road. The service engine soon light came on and I was able to start the car again. The next day I was driving at about 50 miles and hour and the same thing happen twice. The car will nor start unless I give it some gas by stepping on the accelerator. I checked the failure codes and got p0340, bank 1 camshaft positioning sensor failure. Called my Nissan dealer in santa rosa calif. And was told my vehicle was not a part of recall 03v455000. This is wrong. This problem is well known and all 2003 Nissan Murano's should be included. My car has 103,000 mikes.
Murnao has been maintained wth all oil changes/schd mx done by the book. Couple of days ago I was sitting in line at a drive thru and the car abruptly died. There were no warning lights prior to the event. The service engine soon light came on then went back off after a restart. Then yesterday it died while slowing to a stop sign at aprox 15 mph. This time the service light stayed on after the restart. Again this morning it died, this time in traffic while traveling at aprox 50 mph. Parked the Murano and borrowed a friends car for the rest of the day. Did my homework online and noticed the recall for this engine stall. Got the engine codes from a local shop and suprise; camshaft position/crank position sensors. Of course when I called Nissan my VIN is not affected by the recall 03v455000. Contacted local Nissan dealer, est repair costs $600+. Nissan is not holding up its end of thier deal on this vehicle. Please take note, do not buy Nissan.
The contact owns a 2007 Nissan Murano. While driving at 50 mph, the service engine warning light illuminated and the vehicle immediately stalled. The vehicle was towed to the dealer where the failure was diagnosed as a defective crankshaft position sensor. The vehicle was not repaired. The manufacturer advised that the crank shaft sensor repairs would be covered under factory warranty. The contact was awaiting repairs. The failure and current mileages were 50,000.
Can stalls on highway while driving. Service engine soon light comes on. Car will not start--engine will not turn over after this occurs. No accident but could cause accident. Repairman initially stated it was a loose gas cap--tightened and service engine soon light went away. But it happened again yesterday and I stalled out at a light. Car would not start right away. Eventually did start.
Nissan Murano sl. While driving this car in heavy traffic at about 65mph the service engine soon light came on and the car slowed down to a stop. I was unable to get the car going again. This incident happened on a 250 mile drive I could not use my cell because it happened in a dead zone. I had just had the car serviced with a oil change the day before this incident.
The service engine light came on and the vehicle stalled. The dealer stated the crank shaft senor burned up. . The alternator and the control module has been replaced. The crank shaft sensor has been replaced multiple times by dealer.
|Problem Category||Number of Problems|
|Engine And Engine Cooling problems||
|Car Stall problems||
|Check Engine Light On problems||
|Engine Cooling System problems||
|Engine Belts And Pulleys problems||
|Engine Shut Off Without Warning problems||
|Service Engine Light On problems||
|Engine Exhaust System problems||
|Engine Oil Leaking problems||