general problems of the 1998 Acura CL

Driving into work on Thursday the 16th of April, 2015 I was rounding a designated u-turn at approximately 3-5mph. As I was midway through the turn, my car dropped on the passenger side and a scrapping noise started to sound. My car stopped abruptly and a grinding noise made me weary to move. Becoming stationary, I was sideways in the middle of the road with cars approaching. I proceeded to slowly inch my car out of the road and into a safe location with the grinding noise. When I lifted my car up using the jack in the trunk I could visibly see my lower ball joint had come out of the socket and the suspension on the passenger side was collapsed. If this occurred approximately half a mile before the location of the incident I would have been doing 70mph on highway 75. I am lucky that this component failure did not result in the wheel buckling under the pressure of the break. Also I am lucky there were no more than a few cars approaching me when this occurred (t-bone situation). I have been on the NHTSA website to confirm NHTSA campaign number: 99v069000 has been repaired and is for this exact same consequence, which it seems to be. I understand that this may be categorized as a wear component but the ball joint on any car should never come out of place or fail at all. I have recently had to have another item that was already recalled and repaired done again due to the recall not holding up. The issue campaign number: 02v120000 was with the ignition switch contacts spreading resulting in a stall condition and in come cases a no-start condition post stall. The issue was addressed and just re-completed in the beginning of the month so it seems to me that the fixes that are being implemented by Acura seem to bandage the problem instead of a robust fix that will not present the issue in the future. I have already contacted Acura whom stated they will not do anything for me.