Headlights Problems of Acura RSX

1. Hazardous night driving loss of low beam headlight due to poor light socket design and construction. This defect appears to be a burnout light halogen light bulb. 2. The bulb burns out due vibration, or arching caused by the light bulb locking mechanism assembly failure leaving the bulb loose, and held in place only by the protective rubber boot. The lamp socket is held in place by a high tension spring locking into a small hook protruding from approximately 2? diameter thin soft white metal cast disk attached with 2 small screws to the headlight reflector. This tooth shaves off by the spring pressure as evidenced by metal shavings present in base of the reflector. This is not an isolated occurrence, and a brief internet search has turned up many of similar owner reports. Loss of light is often preceded by the blinking headlight. There is a danger of crash due to loss of lights on an unlit highway. 3. The soft metal light socket mount should be replaced by a stamped sheet metal part that would not crack under the spring pressure. The choice of a very soft and thin metal die cast for this part is an obvious error. The stamped part should be also much less expensive then the die cast. The only fix so far is a replacement of the entire headlight assembly with 3 lights at $619. 53 because Acura refuses to make the replacement die cast disk available as a replacement part. Acura service stonewalls the warranty repair requests. In my case, the original dealer has claimed that the light is not able to be fixed under the warranty because car ?had an impact?. The Acura case manager has arranged opinion from another dealer who has said there was ?no impact?, but the user ?must have broken the retaining hook during the light bulb replacement?, hence no warranty service. The issue is that the light bulb has been found loose in the socket, making it impossible to be replaced at night. You need to require that all light bulbs must be replaceable without use of tools.

See all problems of the 2006 Acura RSX 🔎.

Exterior lighting - headlights burn out regularly. Acura dealer has replaced my headlight 4 times while still under warranty. I have replaced those 4 more times myself. Acura denies any faulty manufacturing, but do say that this happens often as the light must vibrate and thus burn out. They also (while under warranty) attempted to blame the problem on non-oem headlights, but they were changed (while under warranty) by the Acura dealership themselves 4 times? therefore this theory of non-oem is not valid. Definite problems occurring are: hazardous night driving loss of low beam headlight due to poor light socket design and construction. This defect appears to be a burnout light halogen light bulb. 2. The bulb burns out due vibration, or arching caused by the light bulb locking mechanism assembly failure leaving the bulb loose, and held in place only by the protective rubber boot. The lamp socket is held in place by a high tension spring locking into a small hook protruding from approximately 2 inch diameter thin soft white metal cast disk attached with 2 small screws to the headlight reflector. This tooth shaves off by the spring pressure as evidenced by metal shavings present in base of the reflector. This is not an isolated occurrence, and a brief internet search has turned up many of similar owner reports. Loss of light is often preceded by the blinking headlight. There is a danger of crash due to loss of lights on an unlit highway. 3. The soft metal clip (seemly not as strong as a paperclip hooked into a very thin plastic hook) light socket mount should be replaced by a stamped sheet metal part- - that would not crack under the spring pressure. The choice of a very soft and thin metal die cast for this part is an obvious error. The stamped part should be also much less expensive then the die cast. The only fix so far is a replacement of the entire headlight assembly. Acura refuses to make the replacement die cast disk available as a replacement part.

The contact owns a 2002 Acura Rsx. The contact stated that the light bulbs in the headlights fail every month and have to be replaced. There is a safety recall on his vehicle's headlights, however the dealer stated that a recall does not exist. The engine size was unknown. The current and failure mileages were 77,000.

See all problems of the 2002 Acura RSX 🔎.

The contact owns a 2004 Acura Rsx. The contact was driving at night various speeds with the activation of the headlights. The illumination of the headlights was extremely dim and obstructed the vision. The manufacturer was notified and they advised the vehicle was not included in the recall associated with NHTSA campaign id number 06e023000 (exterior lighting:headlights). The contact planned to take the vehicle to the dealer for diagnosis. The failure mileage was approximately 50,294.

See all problems of the 2004 Acura RSX 🔎.

Headlight bulbs keep burning out.

The new bright blue headlights are an outstanding inovation when they are properly aimed, however the aim of the headlight is affected by vehicle loading and manufacture and bodyshop/dealer misalligmnment. This allignment is critical. When too much weight is place in the rear of the vehicle, the portion of the headlight that is supposed to be pointing down on the roadway is now directed at oncomming traffic. If manufacturers cannot control this problem by automatically adjusting the horizontal tilt of this lighting system, they should be banned!.

See all problems of the 2005 Acura RSX 🔎.