Two problems related to engine and engine cooling have been reported for the 2010 BMW 650. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 BMW 650 based on all problems reported for the 2010 650.
The contact owns a 2010 BMW 650i. The contact stated while driving 30 mph, the vehicle went into limp mode and then lost motive power, with the engine malfunction message displayed. The vehicle was towed to an independent mechanic, where it was diagnosed and determined that the vanos system had failed and needed to be replaced. The vehicle was repaired; however, the failure recurred. The dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 128,000.
Valve stem seal issue. Car burns excessive oil. More than a quart every several 100 miles. The issue seems to be consistent across this engine model number n62. My VIN number is wbaea5c59acv92776 and as a multiple BMW owner, I think BMW should recall and fix all Bmws with these issues that are appear to be a manufacturing defect.
| Engine And Engine Cooling problems | |
| Engine Stall problems | |
| Engine Oil Leaking problems |