Steering Tie Rod Assembly Problems of Cadillac Catera

Cadillac Catera owners have reported 6 problems related to steering tie rod assembly (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Cadillac Catera based on all problems reported for the Catera.

1 Steering Tie Rod Assembly problem of the 2000 Cadillac Catera

Failure Date: 11/08/2004

The consumer stated that the tires wore out prematurely. The dealer confirmed that the tie rod was bent out of shape. As a result the consumer had to replace all four tires at 6,000 miles. The left front inside wire was showing.

See all problems of the 2000 Cadillac Catera 🔎.

2 Steering Tie Rod Assembly problem of the 1997 Cadillac Catera

Failure Date: 10/15/2002

When braking, consumer states' theres a lot of vibration in vehicles and steering wheel and in the body of vehicle. Took to dealer, dealer states' control arm bushings were bad and needed replacing. Please provide any further information. Ts.

See all problems of the 1997 Cadillac Catera 🔎.

3 Steering Tie Rod Assembly problem of the 1997 Cadillac Catera

Failure Date: 03/01/2000

The tie rod failed causing complete loss of control of the steering (attorney for client). Nlm.

4 Steering Tie Rod Assembly problem of the 1997 Cadillac Catera

Failure Date: 03/01/2000

Outer tie rods failed, causing the vehicle to shimmy and pull to the left and right. This also caused premature wear of the tires. Dealer repaired problem.

5 Steering Tie Rod Assembly problem of the 1997 Cadillac Catera

Front driver's side tie rod broke while vehicle was traveling at 35 to 40 mph.

6 Steering Tie Rod Assembly problem of the 1997 Cadillac Catera

The tie rod failed, it appeared to have been a stress fracture (attorney for client). Nlm.


Other Common Steering related problems of Cadillac Catera



Fuel Economy of Catera Vehicles
Catera Service Bulletins