Four problems related to brake abs warning light have been reported for the 2000 Chevrolet Blazer. The most recently reported issues are listed below.
I have replaced the hub assembly, idler arm, & wheel bearings on both driver & passenger side of my vehicle. When I drive over 45 mph my car makes an awful sound & no matter what I change or have fixed the parking brake/abs lights stay on. Ive had many mechanics look at & say they've fixed the issue but none have actually fixed it. I was driving 70mph on the highway & my brakes felt as if they were locking up.
Abs engages at very low speeds on dry pavement. Brakes slip causing longer braking/stopping distance. Abs light comes on briefly after the event takes place. This presents for dangerous road conditions, especially in town/city environment where often instantaneous braking decisions occur (children playing, animals crossing, etc. ).
2000 chevy Blazer has abs light come on. When this occurs the brakes do not work. It does not matter if the speed is extremely low-or going 55mph-65mph depending on posted speed limit. If you barely touch them it slips/does not grab. If you try to pump the brake pedal it goes to the floor two or three times before catching. You can hear a noise before the abs light comes on-you can feel the brake pedal get tight and then real loose before light comes on. The light does not stay on, nor do you have a warning about it coming on. I just had new brake pads and rotors put on- the brakes should be better than new- however, does'nt matter if they are being told by a sensor or other computer chip/light that they don't work! I've been told it is the abs brake motor valve body assembly part, that is malfunctioning. Please investigate before somebody gets hurt or dies. There is also another woman at my work who has the same vehicle and has the same problem on occassion, they have spent days trying to identify the problem.
Tl-the contact owns a 2000 Chevrolet Blazer. The contact stated that the heater and air conditioner failed to function. In addition, the contact stated that the four wheel drive was activated but failed to engage and the oil pressure gauge displayed an incorrect reading. The abs warning light illuminated. The vehicle was taken to a dealer. The technician diagnosed that the transfer case needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 80,000. Djr.