Two problems related to assist have been reported for the 2021 Chevrolet Blazer. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2021 Chevrolet Blazer based on all problems reported for the 2021 Blazer.
The thermometer and thermometer sensor are glitching . The engine temp needle will not rise at all, the engine fan will run the whole time driving and then when it is turned off will run for 10 min . Right before this happens a notice shows the guided steering is being limited. I disconnected the battery and it reset , I drove and there were no issues , next time I started my car the engine temp needle stayed down and the van started again. This car has 36k miles on it. I just bought it 2 days before it started happening.
"driver assisted reduced use drive with care message" comes on when it is over 70 degrees outside. The temperature gage reads zero, a/c does not work, when the car is turned off the fan runs on high for an extended period of time. Showing code p0128 used car purchase, came on 3 days after receiving vehicle from the dealership. Reset the code came on again 2. 5 weeks later (5/3/2025) when the outside temperature was in the 70's.
| Assist problems | |
| Warning problems |