Horn Assembly problems of the 2000 Chevrolet Camaro

Two problems related to horn assembly have been reported for the 2000 Chevrolet Camaro. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Chevrolet Camaro based on all problems reported for the 2000 Camaro.

1 Horn Assembly problem

Failure Date: 04/01/2001

There is a clunk/rattle/thump coming from the rear end, through the driveshaft. The power window on the passenger side sticks when going down and is slow when going up. The horn has been replaced once for a moisture problem, now is having same problem: also, the horn button on steering wheel doesn't work 100% of the time. Next, the owner's manual doesn't advise when the change rear axle fluid. Lastly, the power steering pump leaks fluid. The cap was replaced once, then it was adjusted. I still have a problem with power steering fluid spewing from under the cap.

2 Horn Assembly problem

Failure Date: 10/20/2000

The horn has two levels of noise, one of the levels of noise completely went out. Upon looking at it, we found that the horn was filled with water (thereby muffling the horn noise). The horn should be a sealed component on the car and should not allow leakage. This care has never been driven in any high water. Thus, this water could only have been accumulated by rain.


Other Electrical System related problems of the 2000 Chevrolet Camaro



Safety Ratings of Camaro Cars
Fuel Economy of Camaro Vehicles
Camaro Service Bulletins
Camaro Safety Recalls
Camaro Defect Investigations