Five problems related to ignition switch have been reported for the 2015 Chevrolet Camaro. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2015 Chevrolet Camaro based on all problems reported for the 2015 Camaro.
The contact owns a 2015 Chevrolet Camaro. The contact stated that on multiple occasions while attempting to start the vehicle, the flip key failed to operate as designed and became stuck in the ignition. The contact stated that to remove the flip key he had to turn the key back and forth to the on and off position multiple times to release the key. No warning lights were illuminated. The dealer was notified of the failure and the contact was informed that there was recall affiliated with the VIN however, the recall campaign had expired. The vehicle was not diagnosed or repaired. The contact referenced NHTSA campaign number: 19e064000 (electrical system). The manufacturer was notified of the failure and the contact was advised to call the NHTSA hotline however, no further assistance was provided. The failure mileage was approximately 104,000.
Newly licensed son was driving down busy 4 lane road when car shut off. He was able to make it to the side of the road safely even though steering became very hard and no acceleration, car started right back up, however we worry about next time. We just purchased the car at the a local Chevrolet dealership. They gave us one key fob, we had to purchase a 2nd key. They would only make a key and fob separately. There is a problem, we believe with the ignition switch. Have checked, it appears to be an issue but there is no recall. Other Chevrolet vehicles with the same issue have recalls, but this one does not??.
I own a Camaro 2015 LS v6. I was driving on a highway at about 35mph, I accelerated and then my car completely shut off. When I looked at my key in the ignition I saw that it had turned into the off position while in drive. I know gm has had multiple recalls due to their ignition switch for the flip-key fob (recall is n192223230), but I am now having the same issue. My key is not attached to the fob, but I show the same symptoms. This is now causing an intermittent connection and the car may stall while driving due to this issue. I believe this is also part of the ignition switch failure recall and should be investigated.
Key gets stuck in ignition switch when trying to turn off car.
Key stuck in the ignition switch. Key can't be removed from the ignition switch.