Table 1 shows one common suspension related problems of the 2012 Chevrolet Corvette.
| Problem Category | Number of Problems |
|---|---|
| Suspension problems |
I am reporting a safety issue involving the active handling/stability control system on my 2012 Chevrolet Corvette. After a routine oil change at grossman Chevrolet in [xxx] on xxx, the “service active handling system” warning appeared. I called the dealership and was told to cycle the ignition several times to reset it, but the warning stayed on. In early xxx, I returned for diagnosis. The dealership determined the steering angle sensor (gm part 25858802) had failed and needed replacement. I was told the part would be ordered and should arrive in about a week. After weeks with no update, I contacted the dealership. On xxx the customer service representative informed me the part was no longer available from gm. He stated the only option was to disconnect the sensor, which would leave the active handling/stability control system nonfunctional. I requested the part number and began searching for availability myself. Over the next two weeks, I conducted daily searches across gm parts suppliers, aggregators, and Corvette specialty sources. No new or nos units were available anywhere. Gm has discontinued the part without providing a replacement or superseding part number. This means the federally required stability control system cannot be repaired and the vehicle cannot be returned to safe operating condition. Gm has provided no remedy or guidance, leaving owners unable to fix a critical safety component. I request NHTSA investigate gm’s discontinuation of this essential part and determine whether a recall or mandated remedy is necessary. Information redacted pursuant to the freedom of information act (foia), 5 u. S. C. 552(b)(6).
The contact owns a 2012 Chevrolet Corvette. The contact stated that while driving 5 mph attempting to make a turn, the vehicle started to skid. The vehicle was taken to the dealer. The technician stated that both front tires needed to be replaced. The vehicle was repaired however, the failure recurred causing abnormal and premature wear of the tire. The manufacturer was made aware of the failure. The failure mileage was 10,300.