Three problems related to ignition switch have been reported for the 2012 Chevrolet Cruze. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Chevrolet Cruze based on all problems reported for the 2012 Cruze.
While driving in the city at night, the vehicle completely shut off, including the engine and all electrical systems without any warnings. This caused all lights to turn off, loss of power steering, power to brakes, and little to control to the vehicle. Luckily, the vehicle behind me noticed and tailed me to a stop with their warning lights. I then proceeded to open the engine with a flashlight to discover that the battery was still properly connected (6 months old) with no frays or corrosion to the connectors or wiring. After about 5 minutes attempting to find a tow truck company the vehicle electrical system came back on with no intervention. I turned the ignition switch and the vehicle started with no issues and no engine lights on. I drove it the rest of the way home with no issues. When I got home I checked all the fuses and all were operable. The obd scanner found no codes. I am mid 30s 190ibs and fairly strong, I could only imagine if this happened in an intersection or during busy hours on the highway, I wouldn't be sitting here reporting this issue. I found numerous similar complaints on blogs concerning this model. I assume not many have reported properly since there is no recall issued for the electrical system.
The contact owns a 2012 Chevrolet Cruze. While driving at an unknown speed, the power steering warning lights illuminated and the headlamps turned off without warning. The contact experienced several electrical issues with the vehicle, including the key failing to dislodge from the ignition switch. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 58,000.
The contact owns a 2012 Chevrolet Cruze. The contact stated that while driving approximately 40 mph over a pothole, the vehicle stalled and hit a curb. The contact was able to restart the vehicle. The vehicle taken to an independent mechanic, who diagnosed that the ignition switch needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The VIN was not available. The approximately failure mileage was unavailable.