Traction Control System Problems of Chevrolet Cruze

Tl-the contact owns a 2011 Chevrolet cruz. The contact stated that when releasing the brake pedal the vehicle abruptly jerked and shook and when the brake pedal was completely released the vehicle jerked with force and shake. The contact had to wait a few seconds for the vehicle to stop jerking and shaking to be able to engage the accelerator pedal. The failure was experienced everyday and the stability control, traction control, and check engine indicators illuminated during the failure. The failure normally occurred when the vehicle was driven at 42mph or less, when the vehicle is driving at 55mph or over the failure was not experienced. However, after the jerking and shaking was experienced the vehicle took to few minutes to engage to highway speed of 55mph or more. The vehicle was not taking to the dealership to have a diagnostic performed. The manufacturer was notified of the failure. The vehicle was not repaired. The approximate failure mileage was 93,000. Li.

See all problems of the 2011 Chevrolet Cruze 🔎.

The contact owns a 2014 Chevrolet Cruze. The contact stated that while driving at various highway speeds, the vehicle would independently enter into limp mode and downshift as the service traction control, service stabilitrak, reduced engine power, and the check engine warning lights were illuminated on the instrument panel. The vehicle would not shift out of first gear once the failure occurred. The contact had taken the vehicle to the dealer on multiple occasions and each time the dealer was unable to duplicate the failure. The manufacturer had been notified of the failure. The vehicle had yet to be repaired. The failure mileage was approximately 30,000.

See all problems of the 2014 Chevrolet Cruze 🔎.

The contact owns a 2014 Chevrolet Cruze. The contact stated while driving at approximately 50 mph, there was an abnormal noise coming from the front of the vehicle. The check engine and traction control warning indicators illuminated. A local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 30,000.

Tl the contact owns a 2013 Chevrolet Cruze. While driving 65 mph, the vehicle stalled without warning. The contact stated that the vehicle restarted itself immediately. In addition, the electronic stability and traction control warning indicators displayed temporarily. Pellegrino Chevrolet in westville, new jersey was made aware of the failure and stated that the failure was no longer under recall. The manufacturer was not made aware of the failure. The failure mileage was 97,000.

See all problems of the 2013 Chevrolet Cruze 🔎.

Ntsb: 2011 Chevrolet Cruze: consumer stated the car goes from normal driving speed, and it will immediately drop to 2-5 mph with a message stating "low engine mode, serice stabilitrack" see 10839439.

The contact owns a 2011 Chevrolet Cruze. While driving approximately 73 mph, the vehicle decelerated and the traction control, power steering, and transmission hot warning indicators illuminated. The vehicle was not diagnosed or repaired. The manufacturer was notified. The VIN was unavailable. The failure mileage was 1,000.

Recently, car radio has been flickering on and off, along with service notifications of stabili trac, traction control. Chevy dealer notified, serviced car, found nothing and has no explanation. Today, stopped at a corner to make a right hand turn. As I was accelerating at approx 2-3 mph around the corner, then steering was lost and could not turn the corner. Lost all control of car. Very fortunate there was no damage or injury to anything or anyone. Scary incident that could of had a worse outcome.

See all problems of the 2012 Chevrolet Cruze 🔎.