Wiring Problems of Chevrolet Kodiak

2007 c4500 Kodiak with dump body 1. Emergency brake failed to hold truck while in gear with motor running: 2. Factory installed electric (trailer brake ) controller failed, & turned on & off at random: 3. The trucks service brakes failed , while trying to stop the truck, (then the trucks brake warning lights & audible alarms came on, then the alarms failed to come on later that night,,, while the brake peddle went clear to the floor boards: 4. The gm (stop lamp switch) was replaced (code) ( dtc # c0164 ) with part number #(15128874) , (while the defective part was not returned to me for inspection) 5. While this (February 22nd, 2007 tech. Service bulletin) (((( #07-05-22-001: brake light switch inoperative, brake warning buzzer sounding and brake warning light on))) described problems with the 2006 kodiak c4500 there should have been a factory recall due to possible brake failures, due to wiring the service brakes to the electric trailer brakes in factory after market installations: 6. Since my service brakes failed, my brake warning alarms failed later that night, my emergency brake was mis adjusted, & by wiring the electronic trailer brakes to the service brake (stop lamp switch), which shorted out this connection,, by drawing too much current thru the stop lamp switch: did cause a situation of total brake failure, with no alarms: 7. This 2007 c4500 with electric brake controller should be recalled with a factory dealer inspection, concerning the defective service brake stop lamp switch, & how the electric trailer brake is wired to the brake pedal, according to the (2) or more gm brake service bulletins, before this truck was sold (new) to me: the defects in the brake warning system,. The service brakes, the electric trailer brakes, & emergency brake, have caused me to file a washington state lemon law claim:.

See all problems of the 2007 Chevrolet Kodiak 🔎.