Seats Problems of Chevrolet Lumina

After I stopped I felt the seat go back. I found the bracket that attached the seat frame to the sliding track had cracked. The metal appears to be too brittle and thin for the application. I am a reliability engineer with significant structural failure background and it appears the thin metal (~1/16") shattered from imbrittlement or some similar process.

See all problems of the 1998 Chevrolet Lumina 🔎.

Passenger's side seat keeps reclining.

See all problems of the 1997 Chevrolet Lumina 🔎.

Sunvisor was repaired by dealer a number of times, but continues to come out of ceiling. Turn indicator - the handle will not return to the off position. Left side of driver seat - all support on the lower portion on the left side of the drivers seat has failed. You must sit on the frame of the seat. The driver weighs only 145 lbs.

On the driver's seat a weld snapped and the drivers seat is no longer stable. The car can be driven but we were told it was not under warranty any longer due to the mileage. We feel that this is a manufacturers defect and it should be corrected by the company. I intend to send a letter to the company also.

See all problems of the 1996 Chevrolet Lumina 🔎.

Driver's side seat tracks/anchors tore/broke away from metal. Dealer notified , and informed consumer to to replace tracks/anchors; consumer believed this condition is a manufacturer's defect, and should not be repaired or replaced at consumer's expense.

Driver seat recline mechanism failed.

Driver's seat separated from anchor. Dealer has been notified.

Metal part that connects seat to the frame track broke, causing seat to fall of track. Please give any further details.