Seat Broken problems of the 2010 Chevrolet Malibu

My driver seat is broke from the bottom of floor and my gas pedal stick and jump when I hit the gas pedal.

Driver seat weld broken.

While driving my vehicle the power assisted front seat moved forward approximately 1/4 to 1/2 inch on the right portion of the seat. This also happened when turning the vehicle as well, e. G. If to the left the right portion of the seat would move forward, if the turn was to the right the right portion of the seat would move back. Eventually the driver's seat sloped downward to the right. This created a hazardous situation while driving. I have owned many cars and never once have I had a seat break like this. Apparently this is a problem with gm vehicles from what I have been able to read. Gm refused to admit that this is their fault and I am out almost a $1,000. 00 to have there problem fixed.

Drivers seat frame broke at two weld areas. Vehicle has never sustained any damage to seat. Seat framed just failed. Dealership and welding shops have all told me this is a safety issue and should never have happened.

Stopped behind traffic and the vehicle behind me did not. Not sure how fast they were going, but fast enough to hit the rear of my car 2 times and push me into the vehicle in front of me. The problem is-- my air bags did not deploy. I am having issues with back and neck since the seat belt did not hold me in place. The drivers seat broke, but the passengers seat belt held, but no air bags.