general problems of the 2003 Chevrolet Venture

The buttons for my control dash where radio and heat adjustment are, the panel,. Gets blazing hot to the touch. Everytime we drive it. It's overheating so much I am concerned it wasn't fixed by a recall previously claimed. The buttons decals have melted off on some buttons. This happens when the car is on. I recently purchased this van privately in illinois.

Tamara inflates includes my brakes as I have to press the brake pedal all the way to the floor and the van would still not stop. Also my driver's side window will not go down.

I have a 2003 chevy Venture and when I purchased it, I noticed that the turn signals would start blinking real fast on the dash. When I would look at them on the outside they were blinking fine, as was the dash lights. This happened several times, so I thought that it was just the bulbs themselves. Then on March 29, 2014, I noticed a little puff of smoke come from the headlight area when my wife pulled into our driveway. I also noticed that the passenger side turn/parking light was out. I luckily had a bulb from another car to replace it, but when I took the assembly out and went to turn the connector to replace the bulb, and noticed it was hot. Thinking that something did not seem right, I let it cool down and then removed it. What I saw was the connector that holds the bulb was black and melted. It actually melted to the bulb itself. I looked at the bulb and it was still good, other than the bottom plastic part. The white smoke I had seen was either the connector catching on fire and melting or the melting of the plastic itself. I never saw any flames. I cannot afford to replace the connector, nor would I risk my family's life, so I have no turn signal. Then worse part is the driver side light was doing the same thing as the passenger, but it has since stopped and is working properly now that the passenger side bulb has been removed.

Signal bulbs keep blowing out, definite electrical problem - brakes no longer work - bulbs are good, they work when you pull the back cases off. Put them on like they are supposed to be, no longer work. Cannot find anything wrong to fix it!.

Problem with the the rear right break light assembly socket board burning out & condensation or water leaking into the assembly also related to cause. Multiple times electrical problems reported & replaced on this vehicle & again on 09/2011 & 12/2011 for same rear break issue.

While turning vehicle stalled. Vehicle was restarted with no problem. Took vehicle to the dealership, but problem recurred.