Steering Tie Rod Assembly problems of the 2008 Chrysler 300

Three problems related to steering tie rod assembly have been reported for the 2008 Chrysler 300. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2008 Chrysler 300 based on all problems reported for the 2008 300.

1 Steering Tie Rod Assembly problem

Failure Date: 06/28/2012

Premature outer tie rod wear/failure please check the angle of the tie rod connection.

2 Steering Tie Rod Assembly problem

Failure Date: 02/07/2011

Tie rods one both front wheels wore out prematurely at 39,000 miles. Premature wear also caused premature tire wear and shaking of steering wheel when driving above 40 miles per hour. Had the issue fixed and the tires replaced, only to have the tie rods wear out again at 57,000 miles. No other issue was found to be wrong with the car. The replacement tie rods wear oem. Second replaced tie rods were aftermarket.

3 Steering Tie Rod Assembly problem

Failure Date: 08/01/2009

Tie rod end severely worn after 17,000 miles of normal use. Caused severe tire wear and tire roll. In addition, made handling of vehicle difficult due to the constant swaying motion. Dealer has replaced defective item.


Other Steering related problems of the 2008 Chrysler 300

Steering problems
12
Steering Tie Rod Assembly problems
3
Steering Noise problems
1


Safety Ratings of 300 Cars
Fuel Economy of 300 Vehicles
300 Service Bulletins
300 Safety Recalls
300 Defect Investigations