Chrysler 300C owners have reported 1 problem related to hazard flashing warning light unit (under the exterior lighting category). The most recently reported issues are listed below.
My turn signals at first were not canceling, and then stopped working completely. However, the right turn signal is stuck in the on position and flashes continuously. Also, after driving for one mile an alert signal starts dinging continuously to let you know that your signal is still on and it never goes off. I have had to remove my turn signal bulbs completely so they would not continuously flash on the outside. This whole situation is unsafe because I do not have any use of my turn signals, and even though I use hand signals people just aren't looking for that . I have even been pulled over by the police for failing to use my turn signal even though I was using my hand signal. Also, in an emergency situation I have no use of my hazard lights(flashers). I have looked online to see if there are any similar complaints concerning Chrysler 300's and I found thousands people with the same issue or in the beginning stages of the the signals failing to cancel.
See
all problems of the 2005 Chrysler 300C
🔎.
| Problem Category | Number of Problems |
|---|---|
| Exterior Lighting problems | |
| Headlights problems | |
| Hazard Flashing Warning Light problems | |
| Hazard Flashing Warning Light Unit problems | |
| Tail Light Switch problems | |
| Fog Light Switch problems |