Two problems related to other fuel system fuel injection system have been reported for the 2000 Chrysler 300M. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2000 Chrysler 300M based on all problems reported for the 2000 300M.
Tl the contact owns a 2000 Chrysler 300m. While driving 15 mph, the contact noticed a strong fuel odor outside and inside the vehicle. Also, the misfire fuel injection warning indicator illuminated. The vehicle was taken to sahara Chrysler Jeep Dodge ram (located at 5050 w sahara Ave #3400, las vegas, nv 89146, (800) 506-5050) where the contact was informed that the fuel supply line tube connected to the fuel injector rail was leaking, which caused the vacuum tube, fuel line clip, fuel supply tube, and fuel vapor to have to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure twice and the contact was informed to file a complaint with NHTSA. The failure mileage was 169,000.
Smelled gas coming from drivers side rear of engine with small drops falling on exaust pipe I looked this up and there was a recall on 1999 Chryslers but did not list my 2000 model. Apparently this problem was never remedied as the previous year was recalled but the next model year used the same parts but was not recalled. I went online checking to see if others had this experience and there were many others that complained of this problem. Most of them said it was from a plastic part that hooked to the fuel line connecting to a fuel injection distribution center. I called a Chrysler parts department at a dealer and was told that Chrysler had changed the way this line was made because of the problems with the lhs and 300m models. These model cars are unsafe to operate because of a faulty manufactured gas line that is something that should never have to be replaced and could cause fires and possible injuries or worse.
| Other Fuel System Fuel Injection System problems | |
| Other Fuel System Hoses Lines/piping, And Fittings problems |