Seat Belt Problems of Chrysler LHS

I was stopped at a traffic light and I was rear-ended by a large SUV. My driver-side seatbelt un-snapped at moment of impact. . My wife was in the passenger seat her belt was fine. . The car was damaged and everybody was ok. . . But was curious why the seatbelt un-snapped. .

See all problems of the 1999 Chrysler LHS 🔎.

I read an article online about defective seat belts model gen3 on Chrysler Lhs vehicles from 1994 thru 2001. I saw videos of how they were tested and how they failed. I checked my seat belts on my Chrysler Lhs 1997 and found that they too failed the test. I contacted the Chrysler dealer but said that my vehicle did not apply to the recall and that I would have to buy the parts and have them replaced. I just recenly obtained this vehicle and I don't think that I should be responsible for unsafe parts installed by the manufacturer.

See all problems of the 1997 Chrysler LHS 🔎.

The gen 3 seat belt system has been proven in a court of law to be defective. In fact, twice in our car the belt holding our sons has released while making a sudden stop at low speed. We fell this belt needs to be investigated further by a federal agency to decide once and for all if these belts should be recalled. So far we have read reports on the internet by abc news prime time and aarca on their websites, so that may be a starting place for your investigation. If you decide to do so to back up our claim. **** dims 11 ivoq entry posted after 12/12/02 cut-over to artemis ****-759698.

See all problems of the 1996 Chrysler LHS 🔎.