Brake Abs Warning Light problems of the 2005 Chrysler Pacifica - part 2

The contact owns a 2005 Chrysler Pacifica. While driving 15-75 mph, the abs warning light illuminated. The dealer was unable to diagnose the cause of failure. Approximately two weeks later, the failure recurred. The dealer replaced the rear abs sensor, however, the failure continued. The dealer inspected the vehicle eight times and replaced the abs sensors and the wiring harness, but this did not correct the failure. As of October 5, 2007, the dealer had not repaired the vehicle. The failure mileage was 12,000 and current mileage was 24,000.

I have a 2005 Chrysler Pacifica and the abs light is on. Has to 2 repair shops and no one can tell me what the problem is. They have tried to pull the codes but no code was available. And the light is still on. One shop replaced the left rear hub assembly because it was not reading. The problem is still there and I am out 200. 00 dollars for the hub assembly. The codes have been cleared several times but the light keeps coming on with no code stored in the computer.

Dating back to the spring of 2006, I have been having problems with the "abs" light symbol constantly coming on in my car. I took it to the dealers on several occasions and told them that when I'm traveling for 10-15 minutes or longer it comes on. They told me that they couldn't find anything wrong and they even test drove my vehicle. I'm very concerned about this problem. I'm afraid that the braking system is going to fail on me all together.

Driving car the abs light comes on, first occurrence Feb. 2006 since then 3 additional times within one month. Recently noticed when abs comes on braking is awkward and on sept. 12 when abs came on felt as if/sounded something was breaking/cracking. Right/left sensors have been replaced but problem keeps occurring.

- the contact owns a 2005 Chrysler Pacifica. While driving 65 mph the contact depressed the brake pedal and it started to move up and down. The contact heard the computer make a loud noise, and the abs warning light illuminated. The dealer stated that the driver's side front hub and the bearings should be replaced. There had not been any other occurrences since the repair. The current mileage was 8,000.

The contact owns a 2005 Chrysler Pacifica. The contact stated that the abs warning light illuminated. The dealer replaced all the abs sensors, however, the light continued to illuminate. While driving 30 mph, the brakes screeched when the brake pedal was depressed. The dealer was unable to repair the failure. The failure mileage was 16,000 and current mileage was 72,000.

Contact states he owns a 2005 Chrysler Pacifica. The contact stated that the abs warning light illuminated . The contact took the vehicle to the service dealer, but the part was not available to repair the vehicle. The dealership was going to have to replace the abs sensor. The dealership consulted the manufacturer to see if the part was available, but it was not. The dealership stated that they did not know when the part will be available.

The contact owns a 2005 Chrysler Pacifica. While driving at various speeds the abs light would intermittently illuminate on the instrument panel . The vehicle was taken to the dealer for a diagnostic. The technician stated the anti lock brake sensor needed to be replaced. After the repair was performed, the failure occurred a second time. The anti lock brake sensor and the master cylinder was replaced. The failure continued after the repairs and the abs light illuminated intermittently on the instrument panel. The vehicle had not been repaired. The approximate failure mileage was 18,480.

Contact states abs light comes on the dash. A service dealer checked it out and found that the left front abs brake sensor was out, and they repaired it on 6-20-05. Now the abs light is back on and the sensor is out again. Contact did not have any problems with this prior to this because he has the car only 2 months.