Four problems related to brake light on have been reported for the 2006 Chrysler Pacifica. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Chrysler Pacifica based on all problems reported for the 2006 Pacifica.
I had the brakes repaired in 2012; the next month the abs light came on and the sensor was replaced. Ten months later, the sensor light came on again. I was told it was insignificant, that the brakes are fine. In the fall of 2013, I had the car towed to a shop because it tried to accelerate while I was pressing the brakes. I spent over $800. 00 having a bunch of codes cleared with the transmission and other things. The engine light was off for a few days but came back on. There was an error that read gas cap. I replaced the gas cap but the engine light remains on. In March 2014 the brake light came on, I was told that I needed to replace the calibers but later was told that I didn't. I had someone else to check and they said that I needed new front brakes. I had those replaced. On 4/7/2014, I was leaving the parking garage at the doctor's office and the gas pedal was stuck. Lucky for me it was on a downhill slope and I was able to stop at the stop sign and put the car in park and press the accelerator to unstick it. Today, April 13, 2014 the brake light is back on and there is a noise in the frontend. I love my car but it just does not feel safe to drive.
The contact owns a 2006 Chrysler Pacifica. The contact stated that the brake pedal pulsated whenever the brakes were applied. A brake light also illuminated on the instrument panel after the failure. The failure recurred intermittently. The vehicle was not taken to have the failure diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was 86,500.
2006 Chrysler Pacifica abs brake lights keep comming on and off time to time.
On January 1, 2007, I was driving the vehicle in my neighborhood traveling at a rate of about 25 mph. As I tapped the brakes lightly to slow down, the brake pedal pulsated rapidly and noticed the abs light turn on. I did not bear down on the brake pedal so I do not know why the abs system engaged. The brake light stayed on for the remainder of the day. On January 4, 2007, my wife was driving the vehicle at lunchtime and the abs system engaged without her even touching the brake pedal. The brakes made a squealing noise at the time. Needless to say, the abs light is back on.