Front Suspension Control Arm problems of the 2006 Chrysler Pacifica

When moving from the humid east to the desert west all control arm bushings and motor mounts dried up and cracked causing over the course of a few week tractions problems made worse when getting new tires and after fishtailing in the rain I brought it to a mechanic that found that all rubber components had dried up. I ended up having to change all control arms and motor mounts which where all cracked and broken.

Tl the contact owns a 2006 Chrysler Pacifica. The contact stated that the control arm and vehicle frame were corroded. There were no warning indicators illuminated. The vehicle was towed to huntington Jeep Chrysler Dodge ram (1220 e jericho turnpike, huntington, NY 11743, (631) 629-6920) where the corrosion was confirmed. The vehicle was not repaired. The manufacturer was notified and did not assist. The failure mileage was 138,000.

Front sub frame rotted out by lower control arms called Chrysler hq they will not cover unless it becomes a recall.

Motor mounts replaced, tie rods replaced, control arms replaced all done in the last month !! why doesn't Chrysler have a recall out on this issues since it's known for it! OH did I mention the gas pedal gets stuck all the time! other thing is my check engine light keeps coming on and off. . . It's been diagnosed as the fuel pump. . . . Really at this point I'm tired of putting money into the car.