Table 1 shows one common seat belt related problems of the 2008 Chrysler Pt Cruiser.
| Problem Category | Number of Problems |
|---|---|
| Seat Belt problems |
Passenger seatbelt locks up, will not perform, I am 75 & wife is 71, danger for our lives. . . .
#10510796, part received Friday 24 may 2013 part installed Friday 31 may 2013 problem resolved. Thank you. Lawrence h. Roe.
Air bag warning light and chime activated. Indicates no airbag deployment and possibly no srs capability. Per lithia Dodge Chrysler Jeep #4, "witech test codes set, b1b57, b1b55, b1b56, b1b54". "replace pass side front seat belt receiver (buckle), on national backorder no eta at this time". Problem, reduced passenger safety, continues chiming at approximately 60 second intervals and bright red warning light; no fix available.
The front passenger-side airbag sensor in the passenger seatbelt quit working after normal use. This causes the airbag light to go on whenever a passenger is sitting in the seat. The seatbelt needs to be replaced at a cost of $300. 00.
Our 2008 Pt Cruiser was going north and a woman exiting an interstate going east ran a red light and hit us. The impact ripped off the front bumper, destroyed the engine, and twisted the front of the cruiser so the passenger door could not open. We were going 35mph I estimate her speed to be 55mph. None of the air bags in the cruiser deployed and the seat belt in the passenger side did not hold the passenger back. The passenger in the cruiser hit the dash causing injuries. The seat belt did not lock or tighten at all. This has to be a defective seat belt because the driver's side seat belt held them back.
I had to have my passenger front side seat belt replaced too as the air bag light and sound would go off when any one sat in that seat. My replacement was under warranty.