general problems of the 1998 Chrysler Sebring

Seven problems related to structure have been reported for the 1998 Chrysler Sebring. The most recently reported issues are listed below.

1 Structure problem

Failure Date: 10/28/2012

I purchased a 1998 Chrysler Sebring lxi the car has numerous problems, one is the control arm in the vehicle. This is a list of other evac problems - I was told that there was a recall on my vehicle for various problems - please advice - need help - called Chrysler dealerships and first they said my vehicle was not affected - then they tell me they can charge me $149. 00 to reset the computer catalyst(g)/nmhccatalyst(d) evaporative system(g)/ unsupportive(d) 02 sensor(g) exhaust gas sensor(d) 02 sensor heater (g) pm filter (d) egr/vvt (g,d) po455 evaporative emission system leak detected (large leak) my headlamps are yellow and my rear window looks like there is some kind of mold sandwiched into the glass and defrost. . . Almost impossible to see out of at night.

2 Structure problem

Failure Date: 07/13/2007

The contact owns a 1998 Chrysler Sebring. While driving 10 mph in the turn lane, the contact's vehicle was struck by another vehicle crossing in the wrong lane. The passenger side, front fender, and alignment were severely damaged on the contact's vehicle. In addition, the trunk would not open, the doors were not installed correctly, and oil was leaking from holes in the engine. The vehicle has been inspected by five body shops and the dealer. There were no injuries, but a police report was filed. The contact has pictures of the damage. The failure mileage was 89,000 and current mileage was 100,000. Updated 06/07/09 the consumer stated the repair facility did a poor job of fixing the vehicle after an accident. Updated 05/08/09.

3 Structure problem

Failure Date: 02/09/2005

The structure inside of door panel warped between the glass and door panel. Driver's hands were cut on numerous occasions. Driver took vehicle to the dealer for inspection, but mechanic could not duplicate the problem. Stated vehicle was operating as designed.

4 Structure problem

Failure Date: 03/15/2003

Don\\\\\\'t know exact dates but had window trim repaired for leaking on left and right side windows and interior covers under door handles replaced for peeling away under orig. Warranty. Called dealership w/I 10 mos. Because same problems came back and was told that I would be responsible for all costs (including rental car) and then I could submit my claim to see if I would even be reimbursed. Car now has approx. 65,000 miles and took it to be diagnosed since I purchased a 75,000/7 yr. Extended warranty. Paid $75 for diagnoses and approx. $30 for rental car and am still told \\\\\\tough luck\\\\\\ on my repairs and that I am responsible even though they have been repaired previously. Oh, and come to find out if I had been informed correctly the first time that my repairs would have been covered because they are warrantied for twelve months!! of course I relied on an answer from an employee at Chrysler/Jeep in southfield, michigan and since they misinformed me I am sol. I have also gone \\\\\\'round and \\\\\\'round with chysler customer service and they have been very unhelpful.

5 Structure problem

Failure Date: 11/22/1998

The car was involved in an accident at 5400 miles, resulting in extensive damage to the front right side. Since this time, the car will not stay in alignment. The steering knuckle, hub & low control arm were replaced but the right camber was still out. The upper control arm & upper strut bracket was then replaced, but the alignment was still out. Next, the camber was raised but align. Was out. The eng. Cradel and porta-power cradel was loosened to adjust nonadjustable camber/caster and the toe was set. On 10/01/99 the car (13,100 miles) was again returned to repair and they found the right front camber again out of align. On 8/18/00, the car, with 19,300 miles was returned again, with two badly worn front tires (one flat). Again, the car was out of alignment. The manager informed me that these vehicles do not hold an alignment (because they're high performance). Is this alignment problem due to the accident at 5,400 miles, or is it an on-going problem with all Chrysler Sebrings?( dot number: tire size: p/215 55 ).

6 Structure problem

Front end is to low, causing failure.

7 Structure problem

The dealer replaced the driver inside panel, however the problem recurred. The consumer stated the vehicle no longer has a warranty. Please provide further information.


Other Structure related problems of the 1998 Chrysler Sebring



Fuel Economy of Sebring Vehicles
Sebring Service Bulletins
Sebring Safety Recalls
Sebring Defect Investigations