general problems of the 2015 Chrysler Town & Country - part 1

Plastic oil filter housing leaking oil causing check engine light to come on. P06dd oil pressure code for not changing to high pressure. Common problem with 3. 6l engine. Can lead to engine failure. Failed housing needs to be replaced with upgraded aluminum housing. This is located under the intake manifold and is an involved repair that is typically in excess of $1,000.

2015 Chrysler town and country lost propulsion power while driving, endangering 2 occupants and surrounding drivers. While driving on a residential road, vehicle came to a stop at intersection. Upon attempting to accelerate from stop and applying gas, vehicle jolted and would not accelerate past 5 miles an hour with transmission engaging and disengaging while shifter was in drive. Vehicle's transmission would intermittently engage and disengage for 1/2 mile with no warning lights or error messages. Vehicle idled as normal, but vehicle would not engage transmission properly when shifter set to "drive" position. Vehicle was then parked in driveway off of the road.

There is a loud ticking noise coming from the engine. A mechanic said it’s a rocket arm failure. He said there are problems with them and were recalled in 2014. After researching the problem, it appears that the problem extends past the 2014 model year. You tube has hundreds of repair videos for this engine. The mechanic said that the problem will only get worse and can cause the engine to stall and miss and it will eventually freeze up causing a possible accident. Please investigate this. I have maintained this vehicle well with oil changes every 3000 miles. Thank you.

In approximately 10 separate instances starting around December 12th when I was driving my 2015 town and Chrysler Mini van, it would lose power and shut off randomly. I would attempt to steer the car to the side or middle of the road (I lost the ability to turn the wheel), shut the car off and turn it back on and the car would start up again no problem. I took the car to the dealership three times for this issue and they were not able to find an issue any of the times I brought it in. It happened once when my daughter was in the car. I was concerned from my safety because I could have been rear ended. I avoid highway driving because of this issue.

The seals in the oil cooler adapter failed. Began leaking oil from the top of the motor down onto the exhaust. This could easily cause a fire when the oil drips onto a hot exhaust. Confirmed by several mechanics and replicated in nearly all vehicles with the 3. 6-liter pentastar v-6 engine. There was no warning lamps. The smell of burning oil was the first symptom. Followed shortly by seeing oil puddling under the vehicle.

Went to garage for vehicle to pass routine inspection. However, the oil filter housing was leaking quite a bit. Due to the size of the leak, I had to pay to replace the oil filter housing and the related fluids. This was about a 3 hours repair. I could not drive the vehicle until the part was replaced. This part failing and leaking at about 85,800 miles seems to have been premature. The garage staff told me the vehicle could not pass inspection until the part was replaced. It seems as if the part has had issues and the newer components may be more durable.

The engine developed a ticking noise. From what I have found, there are defective rocker arms in the engine. Eventually, they will fail and cause complete engine failure which can occur at any time, even when driving at high speeds. This seems to be a serious safety concern. There is a class action lawsuit working its way through the courts, but, there should be a safety recall. Thanks [xxx] information redacted pursuant to the freedom of information act (foia), 5 u. S. C. 552(b)(6).

Two blocks from home my pentastar oil filter housing & cooler line broke and there was oil all over and the car stalled just before my driveway. Could not start it and had a towing company take to meekhof tire & service where I have my work done. Safety was ok. No inspected other than meekhof checking to see what was wrong. There were no warning lights on dash. Chrysler has known about this problem for a long time and never did a recall. So I had to get a used 3. 6lv6 engine.

Oil housing has been replaced 4 times. Since 64k miles, now at 112k. There needs to be a recall. There are so many similar occurances. This is a huge fire hazzard.

Cylinder #1 misfire fuel injectors replaced 4/16/2024; 7/26/2024 cylinder #6 misfire and compression leak. Chrysler refuses to acknowledge additional issue with this 3. 6l engine cylinder head. Customer service disconnected me when I asked to file a complaint. Called the canadian phone number on x56 service bulletin and repeatedly got disconnect.

The vehicle randomly loses all power, which means no power steering and no brakes. It happens randomly and after searching online it appears others have the same issue faced back to the wireless ignition node being faulty. However the previous recall doesn't cover the vehicle I have which is experiencing the exact same symptoms. My wife has already had a close call as she is unable to steer the vehicle without power steering and the brakes don't work at all.

Oil cooler housing leak. Oil leaking all over transmission and engine valley, potential fire hazard. Ticking in engine and metal deposits caused by poor design of cam follower. Destroyed cam and potential for engine to seize up.

My van began to leak oil at a high rate spontaneously one day. I found antifreeze had mixed into the piston chamber as well. Upon further investigation, it appears that the ofa as Chrysler calls it, or the oil filter assembly, has a fatal design flaw being made of plastic and through heat and time these units are prone to cracking. Upon investigating forums, this assembly is used on other vehicles across the fca brands and exhibits the same failure. It is also prone to cracking during the replacement process of the filter as high torque of unscrewing or screwing the filter can crack a portion of the ofa. There is an aluminum version of the ofa that is being recommended for replacement of the oem ofa which to me signals a confirmation of the design defect, however, if the vehicle is outside the warranty, the oem is refusing to cover any of the replacement cost.

Oil filter housing is made of plastic and leaks like crazy it is a known problem with Chrysler.

Several times over the past few weeks the van has just shut off while driving. This has happened at low speeds and at city driving speeds. The engine just completely shuts off and the van loses power brakes/steering/acceleration with no warning, no rough running, no sounds, and no check engine light. The mechanic cannot find anything wrong with it but the problem continues at random intervals. This is potentially very dangerous and even worse is that there is no evident problem.

Check engine light came on and vehicle began to surge. Acceleration was unpredictable. It wouldn't accelerate properly and then would surge forward. I took it to a repair shop and after a accumulating a large diagnostic bill, they said that the lobes on camshaft wore down and are causing misfires. They said it was a well known manufacturing defect and a common issue with this engine.

We have had multiple times when we are driving, and our vehicle shuts off and we lose power steering and power brakes. When the van does come to a stop, we are able to restart it and continue on. There is no warning that the van is going to shut off, it just does it. This is our family vehicle. I have found multiple forms online with customers complaining of the same issue with no positive results from the dealerships.

The engine died while traveling 80mph and power steering stopped. Engine died at a stop light in traffic. No lights display on dashboard and no codes display. Car runs fine after turning off then restarting. This is dangerous and appears common in town and countries. We could have died at 80mph.

Numbers 1 & 2 engine misfires. Van could have stopped running at anytime and cause an accident. Engine light went on. Van is shaking when it runs.

My van has a leak at the valve seat in cylinder 1 on the intake side. It has been inspected my a mechanic and available for anyone else to look at it. My car is not old and low mileage. The mechanic said he had someone recently in with the same problem on the 3. 6l engine, same year, same low mileage. This causes a problem because the combustion is not properly working in the engine so it has a health hazard for everyone because it has a larger and worse carbon footprint because the engine is not working/functioning properly how the car manufacturers intended it to be. I have searched forums and have found multiple people having the same problem with the cylinders. I believe the problem to be with the engine head because the mechanic said when he fixed the other engine he had to get the head off and get it re-machined. Also people are having the misfire in different cylinder. No warning lights were on before the issue happened.

My vehicle is no even at 100,000 and there is a ticking noise, I was told it is the rocker arm and lifter, I was told that this is a constant issue with Chryslers and that this happens constantly. I fell like since I am right outside of the warranty by a few months that this should be covered considering I heard a tick before my warranty was up and was never told that is what it was and every time I took it everyone just brushed it off. This is a safely hazard because I was told I have to wait until this gets really bad before anyone can do anything about it cause no one know which rocker arm is messing up. My car can stop or back fire at any point and all I'm being told is I have to wait until it mess up all the way which is not a good thing. It can stop at any point and someone could run right into me. Yes it was inspected by 2 car places, as well as the warranty department for them to tell me this would be covered but cant be until I get it fixed. There are no check engine lights to show this is a issue and I was told that is really odd that they are no signal lights to show there is an issue with the engine. Please help!!!!!!!!!.

Car passenger headrest is deployed and cylinder 6 is misfiring as described under the recall description from the previous years vehicles recalls.

When driving my van it will chug going up hills or faster then 25mph like the transmission is slipping. The seat belt light will appear and say it's not connected when driving have to keep pushing seat belt in to get it to stop saying driver seat belt unbuckled.

The contact owns a 2015 Chrysler town and country. The contact stated that the check engine warning light was illuminated. The contact took the vehicle to two independent mechanics, where it was diagnosed with needing the transmission pump to be replaced. The vehicle was not repaired. The contact called the local dealer and made them aware of the failure. Upon investigation, the contact associated the failure with NHTSA campaign number: 16v461000 (power train), however the VIN was not included. The manufacturer had not been informed of the failure. The failure mileage was approximately 82,000.

When I accelerate, the vehicle jumps, as if the transmission is slipping. It seems like it does it when it needs to change gears. There aren’t any lights on to indicate anything is wrong, however, this problem is consistent and I’m scared the vehicle will leave my small children and I on the side of the road.

The battery and check engine lights are constantly on despite a new battery, new battery cable, and new alternator. The cruise control will randomly stop working. Abs and vehicle stability lights will go on and off. And at times headlights, dash, and radio screen will flicker and lose power making it impossible to see or know what the car is doing. Mechanic has looked at and repaired the car 3 different times and there is nothing identifiably wrong. The car is now unsafe to drive not knowing when the dash will go out, speed will reduce, or lights turn off. It is a hazard to the driver and others on the road.

Transmission was slipping- Chrysler deal inspected the car and found transmission had low oil pressure due to worn oil pump . They replaced the transmission and oil cooler assemble a recall for a transmission pump seizing causing low pressure has been issued for some Chrysler town& country 2015.

The contact owns a 2015 Chrysler town and country. The contact stated that while her father was driving 70 mph, the vehicle stalled without warning. The vehicle was towed to the residence. The contact called the local dealer but, the vehicle was not taken to be diagnosed nor repaired. The manufacturer was notified of the failure. The contact stated the failure was like NHTSA campaign number: 16v461000 (power train) however, the VIN was not included. The failure mileage was approximately 70,000.

The contact owns a 2015 Chrysler Town & Country. The contact stated that when she stops at a light the vehicle cuts off. The contact stated that no warning lights were illuminated. The contact stated that the vehicle was able to restart after an hour. The vehicle was taken to a dealer who stated that a repair was a waste of money as no diagnosis or repairs were done. The vehicle was then taken to an independent mechanic who stated that the transmission need to be replaced. The transmission was replaced however, the failure occurred. The vehicle was taken back to the independent mechanic who then replaced an unknown filter however, the failure still occurred. The vehicle was then taken to another independent mechanic who stated that a thermostat needed to be replaced. The vehicle was repaired however, the failure was still occurring. The manufacturer was not notified of the failure. The approximate failure mileage was unknown.

I bought my car from 440 Dodge in jersey city NJ, I had mopar insurance for repairs. I bought it back twice for transmission purposes, dealer did change a somewhat sensor to change shifting on trans at no charge cause I was covered but know it's happening again, not shifting accordingly, gas is burning cause of staying in gears that are not shifting. Trans is not slipping but I'm having the same problem on shifting and will stay stuck on same gear and car will keep accelerating wich in some cases l'd have to keep foot on brake, pull over and let system reset. What are my options in this case, thank you.

My engine needs to be replace. The dealer says the upper rod has damaged the engine and the engine needs to be replace ($5200. 00). Also, the actuator in the right sliding door had to be replaced.

I've had to have major work done to my engine and transmission. But the electrical problems are never ending. Most of the electric inside of my car hardly works. Our power doors have closed on my kids several times, the car has locked us in while the alarm was going off and we couldn't get out, it's been stuck on and wouldn't turn off, the transmission is constantly slipping, the windows open and close themselves, many times I've come out of the store and the electric sliding door was open when it wasn't left open, locks lock themselves, car alarm goes off while cars in drive and in park, car hesitates to go and I could go on and on. This car is only five years old !!!!.

Car was running perfectly at 70 mph on the highway and engine cut off without any warning or indication of poor operation, resulting immediate loss of power steering and loss power brakes. This has happened twice in 12 days on Nov 14 and now Nov 26 while driving to whole family to thanksgiving. Mechanic has not been able to duplicate the problem. Very scary. Car has 76k miles. Car will start right back up after 20 min and run perfectly fine. Car has been well maintained with extended warranty.

Tl- the contact owns a 2015 Chrysler town and country. The contact stated that while driving approximately 60 mph the vehicle suddenly shut off causing the power steering and power brakes to seize operation. After gaining control of the vehicle the driver was able to stop the vehicle. The vehicle was towed to the local the dealer umansky Dodge Chrysler of charlottesville located at 960 hilton heights rd. Charlottsville va. Who diagnosed that the main pcm computer was faulty and needed to be replaced. The pcm was replaced and the failure was remedied. The manufacturer was also notified of the failure. The failure mileage was 74,500. Jft.

The car has 25,000 miles on it. Starting out from my house down a hill the power steering and brakes were not working as apparently the engine stopped. I restarted and drove about 15 miles and was on I-26 in TN at 65 mph and the engine rpm dropped to 0, power brakes and steering were inoperable but I managed to get onto the shoulder but was in a dangerous spot with traffic speeding by. Car would start but I was afraid to drive it ass it was not safe if it cut out again on the interstate highway. Had it towed. Still not repaired and mechanic said it showed a code of both bank sensors. E has not found the problem as of yet but I understand Chrysler has had issues with engine stoppage. This is dangerous as my wife would not have been able to control the hard steering and brakes and likely would have wrecked.