Turn Signal problems of the 2007 Dodge Caliber

Two problems related to turn signal have been reported for the 2007 Dodge Caliber. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Dodge Caliber based on all problems reported for the 2007 Caliber.

1 Turn Signal problem

Failure Date: 12/09/2017

When driving on us. 10 in mi at 9 pm head lights went out all other lights work no high or low beams. The bulbs are both good. Also the right turn signal blinks very fast as if there was a burned out bulb but there is not one. This is a 2007 Dodge Caliber. Doessomeone have to getkilled before a recall is forced on Chrysler?.

2 Turn Signal problem

Failure Date: 11/24/2014

The passenger's side low beam and the passenger side brake light have gone out. High beam, reverse, & turn signals are fine. I took the vehicle in and was told the totally integrated power module (tipm) must be replaced at a cost of over $1,000. This is a know issue to Dodge; a design flaw due to exposing the electronic equipment to the elements by placing it in the engine bay in a housing that not water tight. I've been told the with the Caliber it is not a question of if, but when the tipm will go out. This creates a safety hazard because any electrical system could go out while driving. Dodge should either fix this, recall the part, or reimburse owners that have already had to pay to fix the issue.




Safety Ratings of Caliber Cars
Fuel Economy of Caliber Vehicles
Caliber Service Bulletins
Caliber Safety Recalls
Caliber Defect Investigations