Two problems related to loud engine noise have been reported for the 2010 Dodge Caliber. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Dodge Caliber based on all problems reported for the 2010 Caliber.
When I start my car, it starts just fine and then about 1-2 minutes later the engine check sign will come on followed by a red lighting bold on the dashboard. Once the red lightning bolt comes on either parked or driving in a city street or highway, the car immediately starts making loud noises, shakes uncontrollably and speed reduces, sometimes to the point where it shuts off while I'm still driving on the highway or city street. It sort of starts forcing itself to move while in motion. While the light is still on, if I stop at a red light or stop sign and it's time for me to go or the light is green, when I push the gas paddle the car sort of tries to move with pushes, just as though someone was pushing it while parked and then all of a sudden moves with speed. To resolve it, I have to stop on the side and turn the car off occasionally , wait about 5 minutes and then start it for the car to drive normally once again until the red lightning bolt comes on again. The light comes on whether parked or in motion. At times I'd still be driving the car and when the lightning sign comes on, the car shuts off while still on drive in the middle of traffic. I've taken it to Dodge and other mechanics but nobody is able to fix it. It's really unsafe on the road with the sudden stops, pushes and shutting off.
The contact owns 2010 Dodge Caliber. The contact stated that while driving, the vehicle emitted a loud noise. The vehicle was taken to an independent mechanic in the city of cleveland, ohio where it was diagnosed that the engine cradle, the front ball joints, and the rear suspension failed due to corrosion. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 11,009.