Frame And Members problems of the 2011 Dodge Caliber

Two problems related to frame and members have been reported for the 2011 Dodge Caliber. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Dodge Caliber based on all problems reported for the 2011 Caliber.

1 Frame And Members problem

Failure Date: 03/13/2023

The contact owns a 2011 Dodge Caliber. The contact stated while driving approximately 35 mph the contact heard an abnormal noise like "banging" on the driver's side front wheel well, especially when she turned left or when she ran over any bumps. The contact stated no warning light was illuminated. The contact had taken the vehicle to an independent mechanic where it was diagnosed and determined that the front frame members were rusted and the left front steering arm had broken away and needed to be replaced. The vehicle had not been repaired. The manufacturer had not been informed of the failure. The contact stated that the mechanic was aware of a known manufacturer failure about the severe rusting of the frame. The failure mileage was 111,102.

2 Frame And Members problem

Failure Date: 11/01/2019

Tl the contact owns a 2011 Dodge Caliber. The contact stated that the front cross member had holes and cracks, which could cause the front end of the vehicle to fall off. There were no warning indicators illuminated. The contact took the vehicle to an independent mechanic where it was diagnosed with a defective cross member. The vehicle was not repaired. The manufacturer was notified of the failure. The dealer was not contacted. The failure mileage was 160,000.


Other Structure related problems of the 2011 Dodge Caliber

Body problems
8
Frame Rust problems
4
Frame And Members problems
2
Structure problems
1


Safety Ratings of Caliber Cars
Fuel Economy of Caliber Vehicles
Caliber Service Bulletins
Caliber Safety Recalls
Caliber Defect Investigations