Two problems related to brake light on have been reported for the 2011 Dodge Durango. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2011 Dodge Durango based on all problems reported for the 2011 Durango.
Tl- the contact owns a 2011 Dodge Durango. The contact stated while driving approximately 20 mph, the engine stalled without warning. The contact had coasted over to an emergency lane and restarted the vehicle. When the vehicle was restarted the engine,abs and brake warning lights were continuously illuminated. The failure recurred multiple times. The vehicle was taken to the dealer for a diagnosis and the dealer stated that the totally integrated power module had failed. The contact had then received NHTSA campaign numbers:14v530000(fuel system), 14v391000(electrical system) and 14v154000(service brakes , service brakes, hydraulic) and stated that the parts were unavailable. The dealer was uncertain when the parts would become available. The manufacturer had been notified of the failure and the approximate failure mileage was 65,000. Gb.
The contact owns a 2011 Dodge Durango. The contact stated that after having the vehicle repaired according to NHTSA campaign number: 14v154000 (service brakes, service brakes, hydraulic) and having the brake booster replaced, the "push to start" button malfunctioned. The contact mentioned that the brake pedal did not have to be depressed in order to start the vehicle. In addition, the brake lights were constantly illuminated, as if the brakes were engaged, and the forward collision warning alert system was disabled. Also, the abs would activate continuously, but only on the front driver side wheel. The vehicle was taken back to the dealer, but the cause of the failures could not be diagnosed. The manufacturer was not notified. The VIN was not available. The approximate failure mileage was 56,100.