Seat Belt Problems of Ford C-max

The contact owns a 2015 Ford C-max hybrid. The contact stated that when she entered the vehicle, she noticed the rear passenger seat belt was not long enough to latch. No warning lights were illuminated. The vehicle was not yet taken to an independent mechanic or dealer for diagnosis and repairs. The manufacturer was made aware and advised to file a complaint with NHTSA. The approximate failure mileage was 37,000.

See all problems of the 2015 Ford C-max 🔎.

Folded down rear seat. Found both seatbelt (receiver) anchor bolts had not been attached to the nuts on the floor pan.

See all problems of the 2014 Ford C-max 🔎.

The seat belt no longer retracts. It is available for inspection. The dealership has indicated they will charge us to replace the part and labor.

See all problems of the 2016 Ford C-max 🔎.

The driver's seat belt will not retract properly. Results in extreme slack while operating the vehicle. The failure mileage was 78,600.

See all problems of the 2013 Ford C-max 🔎.

The contact owns a 2013 Ford C-max hybrid. The contact stated that the vehicle was taken to Ford of montebello (2747 via campo, montebello, CA 9064 (323) 838-6920) to be serviced per NHTSA campaign number: 16v643000 (latches/locks/linkages). Several days later, the contact noticed that the seat belt indicator failed to illuminate while driving various speeds. The front driver side and/or front passenger side seat belts were unlatched. The vehicle was not taken to an independent mechanic or dealer for diagnostic testing of the seat belt warning failure. The manufacturer was also not made aware of the failure. The failure mileage was 56,114.

Left rear passenger seat belt will not buckle. Will not lock. Grandson use to sit in that position.

The contact owns a 2013 Ford C-max. The contact received notification of NHTSA campaign number: 14v597000 (air bags, seat belts) however, the part needed to perform the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not notified of the issue. The contact had not experienced a failure.