Front Suspension Control Arm problems of the 1999 Ford Crown Victoria

Previously reported under recall # 98v322000. This recall was limited to 1994-1999 Crown Victoria fleet vehicles, natural gas, and Lincoln towncar limo's. A part search shows all Crown Victorias from 1994-1999 use the exact same part number for the ball joints. There is no distinction between fleet, passenger,cng, or limo's. This defective ball joint was apparently used on all 1994-1999 Crown Victorias either solely, or intermittently, but not limited to only fleet/commercial vehicles. Ford is developing a record for performing recalls and/or repairing defects for their "fleet customers" while ignoring the average consumer who is experiencing the same problem. In this case, however, the issue is one of safety, both to the occupants of the defective vehicle and to all other vehicles on the road. I believe Ford motor CO deliberately supplied false information to the NHTSA regarding the scope of this defect. An investigation should be conducted including reviewing accidents involving these vehicles. Currently, my 1999 Crown Victoria (68,000 miles) has the right lower control arm laying on the ground in my garage. I am fortunate it happened while I was putting my car away and not the next day when I would have been traveling at high speeds on the ohio turnpike.

While pulling into driveway wheel fell off . Dealer notified , ball joint was no good.

There is a vibration in the vehicle due to the rear lower control arm not fitting vehicle and not being adjustable. Has seen dealer over 5 times. Dealer has no solution.