One problem related to wiring has been reported for the 2008 Ford Crown Victoria. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2008 Ford Crown Victoria based on all problems reported for the 2008 Crown Victoria.
2008 Ford Crown Victoria has a problem with unintended acceleration. The consumer stated the vehicle accelerated 3 times with no warning. The consumer stated the problem happened when the vehicle was started and placed into drive and driven approximately 150 feet. The rpm's increased without the accelerator being applied. The consumer applied the brake and the rpm's returned to normal after about 30 seconds. The cruise control was not engaged. In June 2009, the consumer took the vehicle to the dealer and they replaced the throttle body and air intake. However, on August 13, 2009 the vehicle accelerated suddenly as it did previously. The consumer took the vehicle back to the dealer and they found 2 pin holes in the basic wiring harness. The consumer was informed the pin holes were a result of the wiring harness being installed upside down which caused tension and rubbing on the wire insulation until the bare wires were exposed which caused a short in the wiring harness. The dealer repaired the wires, but did not replace any parts. To date no further problems have occurred.
| Electrical System problems | |
| Wiring problems |