Steering Knuckle Spindle Problems of Ford E-250

Ford E-250 owners have reported 1 problem related to steering knuckle spindle (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford E-250 based on all problems reported for the E-250.

1 Steering Knuckle Spindle problem of the 2003 Ford E-250

Failure Date: 09/15/2004

A Ford 2003 van, with 30,000 miles experiences a steering failure, when the pitman arm broke off the bottom of the steering box. It cleanly sheared off a shaft of metal which is 1 1/4 inches of solid steel. Since the driver was operating at low speed on the ramp of miami International airport, he struck a barrier with minimal sheetmetal damage. The driver reported that the steering wheel was spinning freely in his hands at the time of impact. I reported this to Ford, who's staff determined that the shaft did not fail due to manufacturing defect. Had this vehicle been at highway speed on a major roadway, the cause of the accident would not have been so clearly obvious. And surely a fatality would have been involved. I retained the broken part. I believe this is an incident which should be reported. Ford determined that striking the barrier caused the metal to fail. However the impact was minimal and though a centered impact on the front of the vehicle the airbag did not even deploy.

See all problems of the 2003 Ford E-250 🔎.




Safety Ratings of E-250 Cars
E-250 Service Bulletins
E-250 Safety Recalls
E-250 Defect Investigations