Child Seat Problems of Ford Expedition

The contact owns a kidsembrace forward facing car seat, model number: 3001min, manufactured date: June 18, 2020. The contact stated that the car seat buckle would not latch. Additionally, when the latch was placed into the buckle the latch failed to fasten securely. The failure occurred while attempting to place the car seat inside the vehicle. The baby was not injured. The purchase date was unknown.

See all problems of the 2019 Ford Expedition 🔎.

I have the graco my ride 65. I had to put the seat in my mother in laws car and can't get it out now. It seems like the latch it locked or stuck. It will not feed any slack to help remove he seat. Normally this seat is in my Expedition and a bit easier to get out however still very hard. I hate to take this seat out and re install often because of this situation. At the moment the seat is currently still stuck in the car. I can cut the straps however don?t want to do that if I don't have too! (related vehicle information: model year=2012, make=expedition , model=Ford).

See all problems of the 2012 Ford Expedition 🔎.

Tl - the contact owns a 1999 Ford Expedition equipped with an evenflo infant child seat, model 3021805, manufactured in 2/1/2012. The contact stated that while driving 20 mph, she rear ended another vehicle and the car seat harness fractured leaving the baby unsecured. The baby occupying the car seat did not sustain any injuries; however, the child seated on the rear passenger side sustained injuries to the neck muscles. A police report was available if needed. The manufacturer was not made aware of the failure. The vehicle was destroyed. The car seat was not replaced. Pm.

See all problems of the 1999 Ford Expedition 🔎.

The contact owns a 1999 Ford Expedition. The vehicle has a 2009 evenflo discovery child restraint seat, model 3021899 (na). The seat was manufactured on January 30, 2009. The child was properly secured in the infant only child restraint seat. The contact observed that the top portion of the harness retainer clip, used to secure the harness straps, failed without warning. There were no injuries. The child restraint seat was installed using the latch system. The restraint seat was replaced due to the safety issues. The manufacturer was notified of the malfunction. The VIN, mileages, and purchase date were unknown.

The seat does not fit properly in the vehicle, you have to prop it up on the back of the seat, so the baby is sitting correctly, then it will continue to slide down then the babies head will fall forward. It also does not have the 5 point harness.

See all problems of the 2005 Ford Expedition 🔎.

Cosco eddie bauer child carseat : manufactured 05/09/2000; model # 02870ebg. Received as a gift 06/2000 and began using appx 11/2000. This seat has an arm/bar that is part of the restraint system. The arm broke while driving on a local highway. The restraint was intact when son placed in the seat. After about 20 minutes of driving (1/2 way into our trip) my older son noticed the arm was loose. The right side of the arm had snapped and was no longer connected to the seatback. The joint is like a ball and socket with a spring. I thought the "ball" of the arm had come out of the "socket" of the seatback, but in fact the arm had broken before the joint. The plastic completely snapped. My son that was in the carseat is only 15 months old. It amazes me that a 15 month old can break part of a restraint system and it scares me to think what might have happened had we been in an accident. My husband and I have purchased a new carseat and chose a 5-point system vs. A seat with an arm/bar. I don't think they're safe. Thank you.

See all problems of the 2001 Ford Expedition 🔎.

Brakes were squeaky and felt spongy, addressed twice, rotors were out by -0. 05. Engine exihibit 'piston slap' documented from day one, dealer stated it may be attributed to octane level, informed by second dealer to downshift, that it will not harm engine, road test by technician diagnosed the pcm was adjusting to load!!nowhere to secure child seat in third row. Heater replaced twice with windows fogging creating poor visibility. Second row single seat fell back upon acceleration,knocking passenger's head back, was stuck and would not reset until pushed very, very hard. Interior dash and headliner squeaks, horseshoe molding tabs around stereo wore through and rattles.

See all problems of the 1997 Ford Expedition 🔎.