Two problems related to speed control springs have been reported for the 1996 Ford Explorer. The most recently reported issues are listed below.
While driving in "d" in first to second it has had a problem shifting between the 1st and 2nd gears when accelerating and will rev high rpms and sometimes do absolutley nothing when drying to move forward unless I DE accelerate and then try to accelerate agine then finally it will catch and go in to 2nd and proceed to 3rd and then 4th and then 5th ,4th and 5th when accelerating sounds very rough when accelerating like it's trying to hard to drive, lately it just the other day I had trouble getting it to go in to d to 1st 2nd 3rd automatic transmission shifting was not wanting to catch had t ok try 3-6 times DE accelerating and accelerating to try to get it to go finalt it caught and I was able to drive it so I stopped at the parts store had them do a scan and the only code that came up was p1701 they looked it up and it said something to do with trouble in reverse witch in reverse has no problem at all so I'm a little confused about it and also a little scared to drive it when this is my only transportation and if it won't engage in to gear when accelerating when in d that could be potentially dangerous also the odometer and speedometer do not work was told it was vehicle speed sensor so I replaced it still had issue so I replaced the odometer spiral gear hopefully it will fix the problem also the back seat double side would not go down fixed it after pulling it apart and drilling another hole into the spring loaded circle that has a tenchener on it fixed that . . . . And the driver and passenger automatic seats just stopped moving about half way so it's very hard for me to reach the pedal and the automatic side mirrors don't work eather one and the all fuses are good theas are all safety issues that have me concerned since it's all I have so anything or anywhere I can take it or do to it please contact me so it can get fixed ASAP for the shifting issue. Ty.
Speed control switch, also known as brake pressure switch on the 1996 Ford Explorer was defective. The thin membrane of the switch was in contact with the brake fluid. As the switch was powered all the time , hot, even when the ignition was off. This was a fire/safety hazard. Ford has already recalled millions of vehicles for this problem, but Ford customer service stated there was no recall for this particular vehicle, and I must pay to have the retro fitted switch installed.