Table 1 shows one common service brakes related problems of the 2021 Ford F-450.
| Problem Category | Number of Problems |
|---|---|
| Service Brakes problems |
The contact owned a 2021 Ford F-450 super duty. The contact stated that while driving 35 mph on an 8 percent decline and pulling a trailer, the vehicle slightly responded upon depressing the brake pedal. Additionally, the transmission failed to downshift and was stuck in 10th gear. The contact pumped the brakes; however, the failure persisted. The contact drove into the shoulder of the roadway, and the vehicle was able to stop. The contact noticed smoke, and upon inspecting underneath the vehicle, the contact noticed that the rear brakes were on fire. The contact was able to extinguish the fire with a fire extinguisher. There was no injury sustained. The vehicle was towed to the residence of the contact's friend, where the trailer was detached from the vehicle. The vehicle was driven to the dealer, where it was test-driven, and the contact was informed that no failure was found. The vehicle was taken back to the residence of the contact's friend. The contact stated that upon depressing the brake pedal to start the vehicle, the brake pedal travelled all the way to the floorboard. The vehicle was taken back to the dealer and traded for another vehicle. The vehicle was being repaired. The manufacturer was notified of the failure and referred the contact to the dealer for assistance. The failure mileage was approximately 78,000.
My 2021 Ford f 450 will not actuate the electric over hydraulic brakes on my gooseneck trailer. I was hauling my tractor to one of my hay fields when a car pulled out in front me. I apply my foot to the brake pedal and the truck and trailer did not slow down liked it use to and I almost rear ended the vehicle that pulled out in front of me. After this I try to apply just the trailer brakes using the brake actuator on the dash and the trailer brakes never operated. I check my fuses and they were good and I checked the trailer using another truck and they worked. I then checked the trailer wiring connections on my truck and they were good. I have done a manual reset on my trucks programming and the truck still will not activate the trailer brakes. Please help.