Blind Spot Detection problems of the 2019 Ford Flex

Four problems related to blind spot detection have been reported for the 2019 Ford Flex. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2019 Ford Flex based on all problems reported for the 2019 Flex.

1 Blind Spot Detection problem

Failure Date: 04/01/2026

The power steering system failed and numerous other electrical systems showed as broken as a result. The dealer service dept said: "we found corrosion on connector c1467a meaning that water is getting inside the connector somehow which caused the module to short out. The steering rack is not the failure, it is the module. However, the module is built into the steering rack. Can't replace it separately. So in order to replace the module, I have to replace the rack. " this failure caused the power steering to stop working, making it extremely difficult to drive the vehicle. The repair cost over $4000.

2 Blind Spot Detection problem

Failure Date: 10/28/2025

Rear camera recall has not been remedied it has be 9 months.

3 Blind Spot Detection problem

Failure Date: 08/18/2025

2019 Ford Flex limited and the rear view camera will come up with a blank screen or a blue screen and not show anything. Then will show the error of camera not available. This problem has been reported in other Flex vehicles and is listed on the NHTSA id number: 24v951000. According to the local Ford dealer, this vehicle is not affected but is showing all the symptoms of it. This occurs intermittently. The camera will work on one reverse, and not work on the next.

4 Blind Spot Detection problem

Failure Date: 06/01/2023

Driver side mirror blind spot warning light is on constantly while I'm driving it never shuts off unless I shut the engine down. Rear backup camera is not working at all. When I go to back up the car I only see a blue screen.




Flex Service Bulletins