Table 1 shows one common electronic stability control related problems of the 2017 Ford Focus.
| Problem Category | Number of Problems |
|---|---|
| Electronic Stability Control problems |
There is 2,800 dollars worth of work I've taken it in twice for the same thing it comes out worse everytime it was built in December 2016 it leaves me sitting in the middle of the road then drives fine it's crazy I need help it has dual clutch transmission.
Car has 71000 miles and June 3rd 2020, the steering wheel locked up and was hard to turn (like power steering with no fluid), turned the car off for 30 seconds and back on and it worked fine. Stopped for food and turned car back on and a warning came up "steering assist fault". Took it to a repair shop and there's no loose wires or bad fuse. Will require to have the steering motor replaced.
So for some reason my airbag light will come on and off for a few weeks. When its on my high beams and dont work and when its off my high beams work. Then today , my car battery randomly died on me twice. It started shaking uncontrollably before then. I thought maybe I needed an oil change because I was close to due for one. When I got it they said my oil was fine and their system checked my battery as working fine too. Also when I try to step on my gas sometimes the car with skid before taking off. Im not sure if anyone else has these issues. I've only had this vehicle for 4 months and it's fairly new. It had one owner before me.
Had my Hyundai for about a year now. There are very serious issue with exterior lighting, brakes lights, rear lights. Break lighting assembly and wiring harness melts and burns to a black crisp, bulbs burst due to severe overheating during "normal operation" of the vehicle. Safety and fire hazard with rear tail light lap assembly, bulb burns extremely hot right through plastic housing unit. Unable to replace bulbs because lighting assembly melts to the socket's core and the socket melts over the bulb metal base. Expect extreme damage prohibiting replacement of any bulbs. After being pulled over repeatedly, informed exterior lights were even after just changing them. . Light bulbs burn hot rapidly, melt to the socket make it unable to get any replacement light bulbs to work because entire unit is then damaged, burnt and melted. Bulb will not fit because plastic unit has melted from circular to inward. Lights fail without the owner ever knowing until its too late. I've been parked at mall police officer informed me light was out, driving on highway pulled over 7 times given warning, repair orders due to lights out, pulled over on side street, road and lights just go out on highway. By the time bulb goes out its burned the entire unit through wiring, anything touching or around it. Change lights every 2, 3 weeks. When changing them I notice damage worsening, metal and bulb are burnt to a crisp. When I replace on side, a week or two later I have to change the other side. Creating a trickle affect. Once one goes out. Another goes out and so fourth. You literally have to replace the entire housing unit which is very expensive. Same repeats. . Did not work. My front exterior light are now out as of a week ago. Meaning I only have 1 working light. I went to the dealership and was told it would be 300 per side to get it fixed because I need new electrical wiring ! seriously !.