Brake Disc Caliper problems of the 2006 Ford Fusion

Started out brake pedal would go to floor and it would take greater distance to stop . I had to start using the e brake to stop the car but now I have absolutely no brakes including the ebrake. I have replaced all the brakes including caliper and still break pedal goes to floor and no brakes. When vehicle is off I pump the brakes the pedal gets stiff but as soon bbc as I turn the key straight to the floor. The other day I had to have it towed home because I lost braking completely resulting in me running a red light avoiding a traffic crash and being pulled over. Needless to say I'm very displeased.

Tl the contact owns a 2006 Ford Fusion. The contact stated while driving 30 mph, the brake pedal was depressed to the floorboard but failed to stop the vehicle. The contact stated no warning light was illuminated. The contact continued to depress the brake pedal until the vehicle stopped. The contact received notification of NHTSA campaign number: 19v904000 (service brakes, hydraulic) however, the part to do the recall repair was unavailable. The vehicle was taken to an independent mechanic and the rear brake pads, calipers and drums were replaced. The contact called smith motor CO inc (359 NJ-31, washington, NJ 07882; (908) 835-8100) where it was confirmed that the part was not yet available. The vehicle was not diagnosed nor repaired. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. VIN tool confirms parts not available. The failure mileage was approximately 152,000.