general problems of the 2006 Ford Fusion

Six problems related to structure have been reported for the 2006 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Ford Fusion based on all problems reported for the 2006 Fusion.

1 Structure problem

Failure Date: 07/08/2014

The contact owns a 2006 Ford Fusion. The contact noticed a protrusion on the passenger side dashboard where the air bag was located. It appeared as if the air bag would deploy at any moment. The vehicle was taken to two mechanics who both stated that the protrusion was not caused by the air bag. The vehicle was taken to a body shop and the mechanic stretched the material to repair the dashboard and closed the opening that was created. The manufacturer was notified. The approximate failure mileage was 62,000.

2 Structure problem

Failure Date: 07/08/2014

The contact owns a 2006 Ford Fusion. The contact stated that the passenger side dashboard was separating which could possibly expose the air bag. The contact mentioned that the passenger side air bag light illuminated. The vehicle was taken to a dealer where it was diagnosed that the entire dashboard needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 53,000.

3 Structure problem

Failure Date: 09/04/2011

First the rear driver's side interior door handle broke when my granddaughter was attempting to open it. Recently the front driver's side interior door handle broke. The fake chrome is peeling off of the passenger side both front and rear door handles. It was peeling off of the two handles that broke but I never thought that they would break. Although I am able to open the window to access the exterior door handle to open the door in most cases, the windows don't always open in the cold weather and the door is very difficult to open using the broken door handle. I am concerned I or a passenger will be stuck in the vehicle and not be able to get out in an emergency.

4 Structure problem

Failure Date: 05/26/2009

2006 Fusion sel. 1) ignition key gets stuck in ignition. Approximately 9 incidents beginning may 2009 of parking the car, turning off the motor, key cannot be removed from ignition: 3-4 times the key could not be removed for over 48 hours; 4 - 5 times within 12 hours. . Car can be locked if using the second remote-control key, but will unlock all doors with in 5 seconds when lock on the inside door is pushed and door is closed. Have had the alarm go off 3 times when car door is opened after car left unattended for 15+ minutes, unlocked, with key stuck in ignition, but alarm has not sounded at all times for the same scenario. 2) chrome veneer on interior front door handles wrinkling and peeling. Problem was beginning to show it self when car was purchased.

5 Structure problem

Failure Date: 06/01/2008

I have a 2006 Ford Fusion that needs a paint job on the roof, because it is peeling. I bought the car new, and have owned it for less than two years. It has 39,000 miles on it, thus making it 3,000 miles out of warranty. Common sense and places I have taken it to consider this a defect.

6 Structure problem

Failure Date: 05/01/2008

Driver's door interior handle has bent and does not open from the inside. Driver's side rear door interior handle has bent and sometimes will not open from the inside. Passenger side front door interior handle has bent but at this time still opens from the inside. Driver's door and driver's side rear door no longer lock due to this.


Other Structure related problems of the 2006 Ford Fusion



Safety Ratings of Fusion Cars
Fuel Economy of Fusion Vehicles
Fusion Service Bulletins
Fusion Safety Recalls
Fusion Defect Investigations